0
The "transom" is the back of a boat or ship. For a small boat, an outboard motor might be attached to the transom; for a sailing vessel, the rudder may be attached to the transom. An example sentence might be:
"We were on our way back to the dock when a fish jumped over the transom and landed in the boat!"
What else can I help you with?
Can you write a sentence using the word transom?
The glass in the transom above the door cracked when it was hit by a ricocheting bullet.
Can you use a short shaft outboard on a 20 inch transom?
No you can not but you can use a long shaft on a 16 inch transom
Where on boat is the transom located?
The transom is the stern of a boat or ship. On a small boat the outboard engine is clamped to the transom.
What is a transom profile?
A transom profile refers to the shape and design of the transom, which is the horizontal structural beam that spans the stern of a boat or ship. This profile can influence the vessel's performance, stability, and aesthetic appearance. Transom profiles can vary widely depending on the type of vessel and its intended use, affecting factors such as water flow, drag, and buoyancy. Understanding the transom profile is crucial for naval architects and marine engineers in optimizing boat design.
Where is the transom located?
At the back of the boat. The transom is reinforced to accommodate the boat motor.
What is a window over a door called?
transom is a bean a window over a door is called a fanlight A Transom IS indeed a window over a door
The transom is the?
At the back of the boat. The transom is reinforced to accommodate the boat motor.
What is the difference between a long shaft and a short shaft outboard engine?
Boat builders manfacture their crafts' in three basic transom heights. The transom height is measured from the top of the transom, (where the engine bolts on), straight down to the keel, (bottom middle), of the boat. A 15'' transom would require a shortshaft engine. A 20" transom would need a longshaft outboard, and a boat with a 25" transom, would require a extra longshaft engine.
When installing an entry door with sidelights and transom--which goes in first--the pre hung door or the transom?
It should be all one unit. If not, you would install the door and side lights and then the transom.
What is a transom plate?
A transom plate is a horizontal structural member that reinforces the transom, which is the part of a boat's stern where the outboard motor is mounted. It helps distribute the load of the motor and provides additional strength to support the weight and vibrations of the motor.
Where is the vehicle identification number on a Yamaha outboard motor?
On the Yamaha outboard, the model number is located on the port, (left), transom mounting bracket. The transom bracket is the part of the engine that is bolted to your boat transom.
How do you install a transom saver?
To install a transom saver, first, position the transom saver against the boat's transom, ensuring it rests securely and aligns with the motor's lower unit. Next, adjust the length of the transom saver to fit snugly, then secure it in place using the provided clamps or straps. Finally, double-check that all connections are tight and that the transom saver is stable, preventing any movement during transport. Always refer to the manufacturer's instructions for specific installation guidelines.
