answersLogoWhite

0


Best Answer
  • _ Cycle the ignition key on-off-on-off-on within five seconds, don't crank engine, only to get dash lights to respond.
  • _ Count the number of times the check engine lamp flashes, pause, and flashes again. First set of flashes is first digit, second digit comes after the pause.

codes and description of trouble are as follows:

11- Timing belt skipped 1 tooth or more from initial learned value; Intermittent loss of either camshaft or crankshaft position sensor. No crank reference signal detected during engine cranking

12- Direct battery input to PCM was disconnected within the last 50 key-on cycles

13- No change in manifold absolute pressure (MAP) from start to run

14- Manifold absolute pressure (MAP) sensor voltage out of range

15- No vehicle speed sensor signal

17- Closed loop temp not reached or engine cold too long

21- 02 sensor problem (oxygen sensor), upstream or downstream

22- Engine coolant temp sensor out of range

23- Intake air temp sensor out of range

24- Throttle position sensor (TPS) out of range, or disagrees with MAP

25- Idle air control motor circuits problem, target idle not reached(+/- 200), vacuum leak found

27- Injector control circuit problem

31- Evaporator purge flow monitor failure or evaporator solenoid circuit problem

32- Exhaust gas recirculating (EGR) system failure or solenoid circuit problem

33- A/C clutch relay circuit problem

34- Speed control solenoid circuits problem

35- Radiator fan control relay circuit problem

37- Torque converter clutch solenoid circuit or park/neutral switch failure

41- Generator field not switching properly

42- Fuel pump relay control circuit problem Auto shutdown (ASD) relay control circuit problem No ASD relay output voltage at PCM Fuel level sending unit - volts out of range Fuel level sending unit - no change over miles

43- Multiple/ single cylinder misfire

44- Battery temp sensor volts out of range

46- Charging system voltage too high

47- Charging system voltage too low

51- Fuel system lean

52- Fuel system rich

53- Internal controller failure

54- No cam signal at PCM

55- End of error messages (If you get this only, no errors were found)

62- PCM failure - SRI mile not stored

63- PCM failure - EEPROM write denied

64- Catalytic converter efficiency failure

65- Power Steering switch failure

User Avatar

Wiki User

โˆ™ 2016-11-23 05:40:32
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you view computer codes on a Dodge Neon?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you view computer codes on a 2005 Dodge Neon?

With a scan tool.


How do you view computer codes on a 96 dodge neon?

You need to have a diagnostic meter to read the codes, then book to tell you what they mean.


How do you view computer codes on a 98 Dodge Dakota 5.2 engine?

You use an OBD scan tool.


How do you view codes in a dodge neon 1997?

with a scan tool, 97 neons are OBDII so they will talk directly to the scan tool. try a parts house has most will read codes for free


How do you view computer codes on a 2003 Dodge Dakota?

turn your ignition to the on position then off. do this for a total of three times, on the third time leave ignition in on position and look at your odometer. your computer will show up to tell you why your check engine light is on.... then search and find out what the codes are.


How do you view computer codes on a 1995 dodge avenger?

if you have the box with the digital miles try turning to key from off to on 3 times and on the 3rd turn keep it on and it should show. if not, refer to the vehicle manual. it should tell you in there.


How do you view computer codes on a 93 Dodge Dakota 5.2 engine?

Either with a scan tool, or by cycling the key on, off, on, off, on and counting the blinks of the check engine light. Two blinks, pause, one blink would be a 21.


How do you view computer codes on a Dodge Stratus?

Buy the manual in Auto parts store its worth it gives you all the details I think its Haynes or Edmunds, Declan. ----------------------- Or just go to an autoparts store (call first and see if they will do it for free) Here most will scan you car and tell you the codes and their meanings for free.


What view displays your presentation on the whole computer?

The slide show view does this job. It can view or display your presentation on whole computer.


The default view in your computer is what kind of view?

Arabic


Is there a site that you can get a list of ADA procedure codes?

There are multiple websites that you may view a list of the ADA procedure codes. Depending on which category of codes you want to view depends on what website you would use.


How do you pop a neon passenger side view mirror back in?

very carefully

People also asked