Want this question answered?
Open up the ceiling box and disconnect the blue wire coming from the light and connect it to the black wire coming from the fan. Be sure and put a wire nut on the wire where the light was connected before you removed it. The wall switch is controlling power to the wire where the fan is connected so when you connect the blue fan wire to that connection you will be sending power to both the fan and light from the wall switch.
You switched the power and switch wires. There should be two sets of wires in the ceiling box. 2 black, 2 white, 2 bare. Two groups of three. The white wire going to the light is the incoming wire. The black one in that group is the power coming in. Take that black wire and connect it to the other black wire. The second black wire goes to the switch. The power comes back to the light on the white wire of that set. Connect that white wire to the black wire in the fixture. The switch should work now. That is if everyone wired the house the way it is supposed to be.
Yes. Simply turn on the ceiling fan while the light switch is in the "on" position. Adjust the spinning to the level of your choice. Now the fan will turn on and off when you switch the light on and off.
.
One possibility is that the connections are loose. Heat is generated. The switch was wrapped in black electrical tape and it is melting. Switch off and get it checked by a qualified electrician.
Open up the ceiling box and disconnect the blue wire coming from the light and connect it to the black wire coming from the fan. Be sure and put a wire nut on the wire where the light was connected before you removed it. The wall switch is controlling power to the wire where the fan is connected so when you connect the blue fan wire to that connection you will be sending power to both the fan and light from the wall switch.
You switched the power and switch wires. There should be two sets of wires in the ceiling box. 2 black, 2 white, 2 bare. Two groups of three. The white wire going to the light is the incoming wire. The black one in that group is the power coming in. Take that black wire and connect it to the other black wire. The second black wire goes to the switch. The power comes back to the light on the white wire of that set. Connect that white wire to the black wire in the fixture. The switch should work now. That is if everyone wired the house the way it is supposed to be.
The light switch is located above the hatch door ceiling.
Yes. Simply turn on the ceiling fan while the light switch is in the "on" position. Adjust the spinning to the level of your choice. Now the fan will turn on and off when you switch the light on and off.
A pull switch is generally a length of cord that is attached to a socket on the ceiling. These types of switches are mostly found in bathrooms, which saves wet hands from coming into contact with an electrical light switch.
.
One possibility is that the connections are loose. Heat is generated. The switch was wrapped in black electrical tape and it is melting. Switch off and get it checked by a qualified electrician.
On the centre of the ceiling (light for rear section)
Some ceiling fans have a black, white and sometimes blue wire. The blue wire in this case is so you can switch a light separate from fan. If your fan doesn't have a light just put a wirenut on extra wire and ignore it. If you do have a light and want it switched you'll need an extra wire run to fan, and switch that wire for light.
You connect it with the same hot wire as the black wire in the fan. It is intended to be tied to a different switch. One for the fan, and one for the light kit.
If there are two black wires, it's possible that it was wired for a ceiling fan and that one of the wires is for the fan part while the other is for the light part. If so, one of the black wires may be switched while the other is always "on." Normally black is "hot" and white is "neutral" (NOT ground... ground is usually green).
Normally red or black is the hot wire and green is the ground. However someone may have used the green wire as the neutral wire which is normally white. Just connect the black wire from the light to the red wire and the white wire from the light to the green wire and see if it works. If not you have to pull the wires out of the ceiling box and see how they wired it.