0
How do you wire a starter solenoid on a 1999 Mercury Sable 3.0?
Wiki User
∙ 14y ago
Starter
Removal & Installation
1. Disconnect the negative battery cable.
2. Raise and safely support the vehicle.
3. Remove the starter terminal cover.
4. Remove the terminal nut and separate the battery starter cable from the starter motor.
5. Disconnect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid.
Ø To disconnect the hard-shell connector from the solenoid (S) terminal, grasp the plastic shell and pull off; do not pull on the wire. Pull straight off to prevent damage to the connector and (S) terminal.
6. Remove the starter motor retaining bolts.
7. Remove the starter motor from the vehicle.
To Install:
8. Place the starter motor in position and install the starter motor retaining bolts. Tighten the bolts to 15-20 ft. lbs. (20-27 Nm).
9. Install the battery starter cable and a terminal nut to the starter motor. Tighten the terminal nuts to 79 inch lbs. (9 Nm).
10. Connect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid.
11. Install the starter solenoid safety cap. If equipped.
12. Lower the vehicle.
13. Connect the negative battery cable.
14. Start the engine several times to check starter motor operation.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the solenoid on a 1999 Mercury Marque?
The starter solenoid is mounted directly to the starter.
What does it means when the second gear stops shifting on a 1999 Mercury Sable?
Solenoid in trans
1999 Mercury Sable starter doesn't disengage after engine starts?
AnswerCould be a bad starter drive - spring broken and not releasing or a bad starter solenoid not opening circuit See "Related Questions" below for instructions on how to remove/replace the starter.
What is a gem module for 1999 mercury sable?
What is a gem module for 1999 mercury sable? And what does it control?
What does this code mean P1744 on a 1999 Mercury Sable?
Trouble code P1744 means: Torque Converter Clutch Solenoid Circuit Performance
Where is the starter solenoid switch located in a 1999 Chrysler Sebring?
The starter solenoid is built on the starter.
Where is the starter solenoid located on 1999 Dodge Dakota?
The starter solenoid on a Dodge Dakota is built on the starter.
Where is the Location of solenoid on 1999 dodge ram?
Starter solenoid? Follow the + battery cable it connects to starter solenoid
Where is a transmission located at on a Mercury Sable 1999?
On a 1999 Mercury Sable : The transaxle ( transmission ) is located in the engine compartment , bolted to the engine
Where is the starter relay on a 1999 GMC Suburban with a big block?
The starter relay on a 1999 GMC Suburban with the bib block engine is located on the solenoid for the starter. The solenoid for the starter is on top of the starter.
What type of motor oil should be used in a 1999 mercury sable?
According to the 1999 Mercury Sable Owner Guide : ( 5W-30 )
What is relay 30 0n 1999 Mercury Sable?
On a 1999 Mercury Sable : Relay # 30 is the Powertrain Control Module ( PCM ) relay
