You don't. Do not power a water feature without a grounded cord.
On a 3 wire dryer cord there is no green wire. The white wire coming from the outlet is connected to ground or the green screw. The black and red wires are the hot wires.
To connect a three prong power cord to a stove, remove the back of the stove and take off the old cord using a screwdriver. Connect the new cord according to the wire colors with the screwdriver.
When flexible cords are talked about the ground wire is in the conductor count. A four wire cord will have black, red, white, and green coloured wires in the flexible cable set. A three wire cord will have a black, white and green coloured wires in the cable set. To use a four wire cord to carry 220 volts just use the black, red and green wires. Connect to the cord ends. Black and red to the outside blade terminal screws and the green wire to the green ground screw. To use a three wire cord to carry 220 volts just use all of the wires. Black and white to the outside blade terminal screws and the green wire to the green ground screw.
Yes, but with a heavier gauge wire <<>> If the cord on an electric heater needs to be lengthened as a perminant feature then the whole cord should be replaced with a new cord of the same type and wire size. What this prevents is aquiring bad splice connections at the point the connection is made. Bad splice connections will create hot spots in the cable. If the lengthening of the cord is just a temporary fix, just use an extension cord. The extension cord should be the same wire size as the heater cord. Keep the extension cord under 20 feet in length.
The ribbed wire on a lamp cord is the neutral wire. On an extension cord there is no rib but the neutral wire is white in colour.
Cord
The neutral wire will have writing or ribs on it and connects to the white wire. The smooth wire is hot and connects to the black wire. Use 3 strand wire in size AWG # 16. If the fan has a light it will have a blue wire. Connect that blue wire to the black wire.
120v and 240v cords usually have different end configurations and will not plug into the different recepticles. However, if you changed the plug end, and the cord has the proper size rating, then yes, you could use the same cord. But, it also depends on the cord too. Most 120v cords only have three wires in them. One "hot one "neutral" and one "ground" wire. A 240v cord would have FOUR wires, two "hot" wires, one neutral wire, and one ground wire. Therefore, if you changed the voltage from 120v to 240 using a 3 wire cord, you'd not have a ground wire and that could be VERY dangerous. Note that occasionally a 240v device (e.g. some motors) will only need three wires (red,black,green, no neutral) and can be wired with a 120v cord if the cord is rated for 240v.
Black wire to the gold screw, white wire to the silver screw, green wire to the round or U shaped prong screw.
To answer this question the voltage and the amperage of the cap must be stated. Then the termination letters can be given.
flat cord it is an electrical supplies or material ^-^
He do you splice and rewire an iphone4 cord