You need two separate switches. You can get two switches that are in the same form factor as a single switch (2 gang switch). You use one switch for the outlet and the other for the light. You switch the black wires which are "hot".
Could be a loose connection somewhere, or a bad switch, or a bad outlet.
Warning: This is NOT a detailed tutorial but rather an overview of the concept that omits any mention of basic electrical safety procedures or any existing wiring alternatives or obstacles you might encounter. If you are not familiar with electrical code and permits, do not attempt this. Split the hot/black wire and put the side coming from your service panel on the top lug of the switch, and the wire going to the receptacle on the bottom lug. Don't forget to connect your ground to the switch. Depending on your application this may not be legal under the current electrical code.
Yes, just make sure it is a 220 volt switch.
Like any other switch: you fasten a pigtail to the screw terminal and use wire nuts to connect all other wires to the other end of the pigtail. Why you would ever want to do that in a 3-way would be a head-scratcher for a different question.
Home depot sells RF switches whereby if the fan is connected to the transmitter. It can be controlled by as far as 5 meters i believe In my SPA i have this device for safety. switch here get turn on there
A single pole switch controls a light or outlet at one location. A 3 way switch controls a light or outlet from 2 locations.
Yes you just have to "steal" power from the switch. Do this by running a pigtail wire from the hot of the switch to the hot wire of the plug. Make sure you do this before the switch or you will end up with your outlet being switched as well.
If there is a black wire going from the outlet to the switch and the other side of the switch goes back to the outlet then just cut these wires and connect supply wire directly to outlet. If the supply goes to the switch first, disconnect from switch and connect the two wires with a wire-nut. Some situations only switch one of the two outlets in a duplex device. Do the same thing, but also replace the outlet since the strapping between both outlets has been removed.
You will need a receptacle that you can wire each outlet separately (not jumpered). You would then wire the switch in series on the line conductor with the outlet you want switchable. Wire the other outlet directly to the power source. You can jumper the neutral from one outlet to the other.
If you don't know, don't try it, it could be dangerous. You need an electrician to teach you.
You have checked the wire at the switch? Breaker may be bad but not tripped. Loose connection at light or outlet that the switch controls. Use a screwdriver to touch the two terminals on the switch if you do not have a tester. May not be hot side of the circuit, but the neutral.
See: "How can you re-wire a wall switch that controls an outlet to control a ceiling fan?" (Follow the link below.) The procedure is the same whether the new device is a light fixture or a ceiling fan.
Could be the switch and pigtail at fault or the high speed relay.
No, that is not unsafe.
Could be a loose connection somewhere, or a bad switch, or a bad outlet.
Dirty/weak/loose electrical connections at switch causing resistance, causing heat, causing switch and plug pigtail to melt down. You need to replace switch and plug pigtail. Both items may be available from your local auto parts store or Chevy dealership.
ask them how