This thing puzzled me too! Then I thought, it's a "pull apart" key ring. Sure enough, pull one of the end rings and that section pulls off!
Saturn has a bigger ring system than any other known planet. It's ring system was made of a small moon ripped apart by Saturn's gravitational pull.
ring pull tabs are made of aluminum
Ring a ring o' rosie.
To remove the handguard on the M16 assault rifle, first remove the magazine. Next pull back the charging handle and inspect the chamber to ensure that the weapon is clear. Now place the rifle on the ground with the buttplate on the floor and the muzzle facing up. Pull down on the delta ring with one hand, and pull apart the handguard with the other. If you have an M16A1, the handguard will come apart down the middle. If your M16 has A2 or later style handguards, they will come apart to the left and right. M16A1s lack a flared delta ring, and may require a tool to pull down if you lack sufficient strength.
remove twist ring and pull out. lift wire retainer pull light loose from electrical connection put it back together the way you took it apart you should have no trouble
Depends on the ring. If it's a stud then you change it like any other ring. If its captive ball or something like that then, well with mine, you have to pull the sides apart until the ball pops out.
The thing on top of a can is usually a lid. Pull tab or pull ring .
My Model 101, from 1963, has the ring pull out bolt. It is original factory equipment.
no its not necessary.
put butter on your finger so your finger is slippery and pull off the ring
it is called a pull tab Also known as a ring pull.
You have to drop the tank and pull the slip ring and pull it out