answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you you remove printed ink on rubber belt?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can you remove block printing ink from rubber?

You can ink by smothering the rubber in vasaline and bleach


How to clean a rubber stamp?

If it has water-based ink; then just use dish washing soap and water. If it is another ink, there are various products that can help you remove ink from the rubber.


What is the effect of sunlight on rubber ink and paper?

the ink will soon fade, the rubber will lose its strechiness and the paper will stay white


How can you imprint a logo on glass?

Glass is printed by either screen printing with a solvent based ink. Or pad printed with a solvent based ink.


How do you use Dixon pink n ink erasers to remove ink?

They won't remove ink unless it is eraseable ink.


Can rubber stamps be used on food?

You can use rubber stamps with food if you use a food colorant as an ink as normal stamp ink is toxic


What devices read text printed with magnetized ink?

MICR readers are one type of device capable of reading text printed with magnetic ink.


How do you adjust the timing belt on 1990 Volvo 240 dl?

Take the timing cover off, and DO NOT loosen the tensioner pulley, BUT check for alignment of the gears. Check tension of the belt, on the long side, by twanging it with one finger (putting one finger under the belt in the center of the long side, and pulling lightly out and allowing the belt to vibrate.) if it doesn't twang for 2 to almost 3 seconds after you do this (vibrate for almost 3 seconds, then it's too loose.) A special tool is normally used to tighten this belt after loosening the large nut holding it. After adjustment, turn the engine over with the crank nut 3 full revolutions, then recheck belt tension. The main next thing to check, is the amount of printed ink still remaining on the back side of the belt. To check the ink: turn the engine over with only the crankshaft pulley bolt, NEVER by the timing gear bolt, until the printed ink comes into view. The ink is bright white or yellow when the belt is new. When the ink is 90% gone, then the belt is 90% worn. This is a freewheeling engine, so if the belt breaks, it will not normally damage the valves.


Does nail polish remove pen ink?

No, nail polish can not remove pen ink. Nail polish -remover- might remove pen ink but I am not sure.


What is the blue bit of the rubber for?

to erase ink apparently


Remove ink stain from wet clothes?

how do i remove ink stains from wet clothes


Devices read text printed with magnetized ink?

MICR