0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Will an 8 ohm speaker work with an 6 ohm amplifier?
Yes, but it will not be as loud as it would have been had a 6 Ohm speaker been used. Byt the way, the word 'Ohm' is capitalized, because it was someone's name.
What is the difference between a 8 ohm speaker and 12 ohm speaker?
Study ohms law to get your head around it.
Will 8 ohm speaker work with 4 ohm bass guitar amplifier?
Yes. As long as the speaker impedance is higher than the minimum rating for the amplifier, you are OK.
How do you make a 16 ohm speaker 8 ohm?
You cannot make a 16 ohm speaker into an 8 ohm speaker. You would need to replace the voice coil. You can, however, put two 16 ohm speakers in parallel, and the equivalent impedance would be 8 ohms. The only remaining issue is frequency response, and that's a factor of speaker and enclosure design, so best is to use the exact speaker as originally designed.
How do i Make a 8 ohm speaker 16 ohm?
You can't change the ohm load of a speaker. What you can do, is get a second 8 ohm speaker to run with that speakers in series and you will get a total ohm load of 16 ohms.To run them in series, simply wire the positive terminal of one speaker to the negative of the other speaker. One speaker will have an open positive terminal which you wire to the positive terminal on the amp, and same goes for the negative on the other speaker (to the amp's negative terminal of course).
Will 8 ohm sub woofers work with a 4 ohm amp?
if you put 2, 8 ohm speakers together on the same channel you will trick the amp into seeing a 4 ohm load, it is not advisable to run a 8 ohm coiled speaker on a 4 ohm amp unless you do the above. So if you want to run 2 8 ohm speakers from a 4 ohm amp this will work the best although the amp will need to be hefty as its worse to underpower a sub than overpower it! I have used a 8 ohm speaker myself on a car amp and had no problems but it was not a cheap entry level amp! some amps will take it, others will get hot and enter protection mode. Hope this helps!!!
What is the cost of a 3 watt 8 ohm speaker?
the basic operation of 3watt 8ohm speaker
Can you connect a 8 ohm speaker for a amp designed for a 4 ohm load?
You can, but the available power will only be about half of rated, and the frequency response will be slightly different. Better would be to connect two 8 ohm speakers in parallel, making an equivalent 4 ohm speaker.
Can 8 ohms horn driver work in series with a 16 ohms horn driver?
Yes, on 8 ohm horn driver will work in series with a 16 ohms horn driver, but it will not work well.An 8 ohm speaker in series with a 16 ohm speaker will only present a load of 24 ohms to the amplifier. (Assuming they have the same frequency to impedance curve.) That will result in one third the expected current, and one ninth the expected power. Also, since each speaker represents inductance, it will act in part as a filter, affecting the frequency reponse of the other speaker.
How many ohms would 2 16 ohm speaker cabinets and 1 8 ohm speaker cabinet calculate out to be?
If wired in parallel then 4 ohms.
How do you use 16 ohm monitor speakers with an 8 ohm powered mixer?
Just use it like an 8 ohm speaker or else connect two 16 ohm speakers in parallel to form an 8 ohm load. Parallel is positive to positive and negative to negative.
Can resistance be added to speakers to make a 4 ohm speaker have an 8 ohm load?
You "can" add a four ohm resistor in series with a four ohm speaker, and make it look like an eight ohm speaker, however, the frequency response will not be the same. It is better to use to correct speaker for the amplifier, or use two four ohm speakers in parallel. That resistors power rating must exceed the rating of the speaker. Half the from the amplifier will go to the speaker, while half will go to the resistor, making it get quite hot.
