answersLogoWhite

0

How does a Diac work?

Updated: 8/10/2023
User Avatar

Wiki User

13y ago

Best Answer

A DIAC operated with a DC voltage across it behaves exactly the same as a Shockley diode. With AC, however, the behavior is different from what one might expect. Because alternating current repeatedly reverses direction, DIACs will not stay latched longer than one-half cycle. If a DIAC becomes latched, it will continue to conduct current only as long as there is voltage available to push enough current in that direction. When the AC polarity reverses, as it must twice per cycle, the DIAC will drop out due to insufficient current, necessitating another breakover before it conducts again

User Avatar

Wiki User

13y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

10y ago

A DIAC is a diode alternating current switch. Its construction consists of two back to back diodes. It is usually used for triggering TRIACS.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How does a Diac work?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Difference between diac and triac?

The diac and the triac are used to control the AC lines. The difference is that triac are bigger than diac.


Circuit diagram of illumination controller using diac and triac?

a circuit diagram consist of diac&triac


What is a DIAC?

Diac is a bidirectional electronic switch that can pass current in either directions according to the polarity applied on it.


Can a diac trigger scr?

No, a Diac cannot trigger an SCR because when the Diac turns ON, the current through the Diac is around 9 mA. The gate threshold current of an SCR is typically 5 mA, which is less. So the SCR can get damaged due to this high gate current.


Can you equivalent the DIAC and comment?

A DIAC is a full-wave or bi-directional semiconductor switch that can be turned on in both forward and reverse polarities.


Can DIAC be replaced by two anti-parallel diodes?

i think not.diodes have a low breakdown voltage, around 1v. a diac has bv of about 30v.


A diac is equivalent to a?

pair of for layer of SCRS


What is function of DIAC?

A DIAC is a diode alternating current switch. Its construction consists of two back to back diodes. It is usually used for triggering TRIACS.


What is the Full form of DIAC?

diode for alternating current


Give the name of termials of DIAC?

Did I Act Crazy


Application of diac?

The diac acts like an open-circuit until its switching or breakover voltage is exceeded. At that point the diac conducts until its current reduces toward zero (below the level of the holding current of the device). The diac, because of its peculiar construction, does not switch sharply into a low voltage condition at a low current level like the SCR or triac. Instead, once it goes into conduction, the diac maintains an almost continuous negative resistance characteristic, that is, voltage decreases with the increase in current. This means that, unlike the SCR and the triac, the diac cannot be expected to maintain a low (on) voltage drop until its current falls below a holding current level.


What is the advantages of DIAC in electronic devices?

it help student study better