calculate speed drive pulley.
both lift same speed both lift same speed
there are many advantages of pulley and they are it change the direction of force
yes
a pulley
A single pulley system is used to change direction of the pulling force line.
1-To force change. 3-to move to change. 4-speed. 5-force 6 We high-speed we at least. 7-force at least.
If the load is connected to the motor via belts, you can change the speed the load is turning by changing the pulley sizes. To get the load to slow down, increase the size of the pulley on the load; to get it to speed up, increase the size of the pulley on the motor. To reduce the speed of the motor itself, you'll have to alter the line frequency, which you can't do without a variable frequency drive attached to the motor.
Think about your ten speed bicycle. The bike is in the lowest gear when the front sprocket is on the smallest diameter and the rear is on the largest. On the contrary, when the bike is at high speed, the rear is on the small diameter sprocket and the front is on the large diameter sprocket. Therefore, increasing the drive pulley size will increase the driven pulley speed (assuming the drive pulley stays at the same RPM). Similarly, increasing the driven pulley size will result in a slower speed (again, assuming the drive pulley stays at the same RPM).
both lift same speed both lift same speed
It depends on the snowblower, belt type and what you arer trying to achieve by making the change. The replacement pulley(s) will have to be the same shaft id as the original to start. Next make sure that there is room inside the snowblower for the new pulley. Thirdly the belt may have to change depending on the pulley size that you choose. There are many different pulley types and sizes available. Be aware of the changes that are made because they can decrease the snow throwing ability and also affect the drive speed and vice versa.
Fixed Pulley and Compound Pulley.
there are many advantages of pulley and they are it change the direction of force
Most are belt driven and have a step down pulley on the motor and the drill. Changing the groove the belt is in changes the speed of the drill. Small groove on the motor and large on the drill will give you the slowest speed.
force
remove the varable speed pulley-replace both belts re-install varable speed pulley--your done.
yes
your questoin is not specific, there are many pulley's