A transformer has a primary (Where the AC supply voltage is applied); and a secondary where a voltage is induced by a fluctuating magnetic field in the iron core of the transformer. The secondary voltage depends on the ratio of windings between the primary and secondary. Since the transformer can't manufacture power the product of the voltage and current at the primary exceeds that in the secondary. So if the transformer steps up the voltage in the secondary, the maximum current in the secondary must decrease. Similarly if the voltage is stepped down the maximum current increases in the secondary. There are always losses in this process so the power in is always somewhat less than power out.
The pulses are high voltage low current.
When we give d.c supply to a transformer the primary winding will burn because constent flux will be will be produced which doesnt link with secondary so max current will circulate on primary winding only
ya mom u stupid noob. what do u expect from a sentace that doesnt make sense. ure metal.
you must check the voltage and current rating for the heater, the power itself doesnt matter Concur - Some heaters may be rated for the higher voltage which requires less current to run. Watts = Current * Voltage. You risk a fire if you try to run heater above its rated values which should be on a plate on the appliance.
no it doesnt
Nah doesnt exist
Since Batteries work on DC then it doesnt matter wheter or not they are European or American, as long as you choose the right Voltage and Current for the batteries.
direct current
No because real money supply would only increase if the price level doesnt increase or increases at a slower pace than the increase in nominal money supply. This is because the real money supply takes into account the current price level.
DC Analysis: For this analysis, frequency is made zero and the voltage of the source is increased in small steps from 0V.And the output voltage is plotted. So, finally we get a Vout vs Vin curve. AC Analysis: In this analysis, we choose an AC source. We keep the Offset voltage = 0V, AC voltage or small signal voltage = 2V (You can take any voltage you wish and it doesnt matter). So, to plot the ac response or frequency response of the circuit, increase the frequency in steps and note the output voltage. from this analysis , we can find the gain of the circuit over frequency.
only if you have an allspark. A little known fact is that it doesnt actually exist.
it doesnt a lime produce's more voltage than a lemon