the tank must have a graeter amount of energy because it has to heat up more water there for it requirs more energy to do so
Latent heat is the amount of energy that is needed to change the state of matter. Either from a solid to a liquid, from a liquid to gas or vice versa. For example if you boil a kettle of water, energy or latent heat is added to the water from the element within the kettle. The water will heat up and eventually turn to steam.
-kettle -electric heater that's all i have! :)) When a current passes through a wire, the wire heats up. This is caused by the conversion of electrical energy into heat energy. /the heat produced depends on the resistance of the wire.
It is able to heat the water quickly so that it is ready on demand. The copper plate underneath helps to heat up this water.
The cooler will warm up the water in the reservoir until it is boiling, then it will turn off. After a couple of minutes, it will turn back on again and heat the water till its boiling again. That's why the water is always hot because the cooler is constantly heating it up like if you kept turning a kettle on.
To heat up water *facepalm*
The kettle has to be plugged in to an energy supply before it can heat up.
the tank must have a graeter amount of energy because it has to heat up more water there for it requirs more energy to do so
they heat up water in your kettle
To heat up water *facepalm*
If you mean the 'electric POT' that heats up water, it is probably an "ELECTRIC KETTLE".
Electric kettel:Electricity travels through the element inside the kettle, but resistance to the flow of electricity causes heat. The heat is then conducted into the water. When the water reaches boiling point, the steam heats up a 'Bimetallic Strip' which is made up of two different strips of metal, which bends because one of the metals expands faster than the other. This breaks the circuit, and the electricity doesn't get through the element until the bimetallic strip has cooled down.Non-electric kettel:It works by the plate on the bottom of the kettle heats up then it will heat the water up to boiling point
Polly put the kettle on to heat water for making tea or coffee. Heating the kettle is a common practice to prepare hot beverages in many households.
When you put the switch on, the electricity goes thought the wires heating the melt prongs, which heats the kettle and the water. When you put the switch on, the electricity goes thought the wires heating the melt prongs, which heats the kettle and the water.
Electric showers only take water from the mains cold water supply. They heat the water when you turn the shower on, by passing it over a heating element inside the shower - in a similar way to how a kettle works. When you shower, you don't use up and stored hot water - so electric showers are ideal for families and households where there is a limited supply of hot water. Electric showers are always ready to use, any time of the day or night
It is not an element... for hard water usually a build up calcium compounds.
The boiler will heat up the water that comes out of the tap or is used in the radiators. Also the kettle will heat up cold water to make a cup of coffee or tea