with combustion .. their are 3 componats of combustion -gas - air - and spark .. which creates combustion
An engine is a motor that converts thermal energy to mechanical work.
The motor mounts on a 4.3 Liter Chevrolet will not work with a 5.7 liter engine. The motor mount from the 4.3 Liter will not be strong enough to hold the weight of the 5.7 liter engine.
Replace blower motor resistor usually located in the duct work or out in engine compartment in ductwork by heater motor.
no
No. The Prism motor is a Toyota motor and side mounted. The Tracker motor(suzuki) is mounted with the engine from front to back, so it will not work without a lot(I mean a lot) of work to do it.
Yes you can 351 and a 302 are pretty much the same engine block. the motor mount will work.
Yes if the bell housings match up to the engine bolt pattern.
Go to a local machine shop that does engine work. They will explain the procedure for boring an engine in detail. This is where you will have to go to get your engine bored.
Check your blower motor relay!
The engine works when the fuel is pumped to the wheel. The fuel liquid becomes to gas!
The engine works when the fuel is pumped to the wheel. The fuel liquid becomes to gas!
The blower motors only work with the engine running. If the blower motor has three wires on the electrical plug, then the blower motor module is built into the unit & it's very expensive. Sometimes, you can tap on the motor with a hammer & it may work or slowly turn. If this is the case, replace the blower motor.