What type of caulking as lead caulking expands when heater other laytex shrinks PLEASE be more discriptive
If there is no caulking joint there then you just don't "creat" one. If there is in fact a joint with old caulking it then yes you can remove 100% of the old stuff and use Deck-o-seal.
Electricity, Heat, Natural obstacles during daylight hours
An increase in temperature will reduce the density, reduce the viscosity, reduce thermal conductivity, and increase the specific heat capacity. A decrease in temperature will have the opposite affect.
thermodynamics, is essential for mechanical engineers, because the subject is mainly about heat and work in system, and as an engineer that is important, especially when you have to design engines, because that is when you have to determine important factors such as the amount of work that can be done by that engine internally, and the heat it transefered and obtained.
If you live in an area that has temperature below 32 degrees F during the winter you need to caulk joints. Water can get in the crack and cause freeze cracking. Water expands when it is frozen.
Caulking that has little or no silicon does not shine and is paintable . A popular type is Alex ll. This is definitely my favourite for indoor caulking EXCEPT in bathrooms.
Heat does not affect it. It expands with coolness. It contracts with heat.
No.
Heat can affect the molecular composition of an object.
you should budget about 50 dollars a window - that should include taking the hold caulking off and installed backing rod with the new caulking.
It is not stated in the question. But, assuming the caulking (tar and untwisted rope) has been used to seal ship or boat planking. Heat the old caulking and remove while hot with a flat hook or knife. If I've read the question wrong, then more information is required.
Caulking board mean that Joe Cullen`s mum is miss Williams.
I believe that you mean acrylic caulking, not latex. In any event, not all brands are the same; sometimes there is an inner seal of aluminum foil that you have to puncture before you can extrude the caulking compound, but usually there isn't. You slice off the tip of the tube, and since the tip is tapered, you get to choose the side of the opening that you want, for heavy caulking or light caulking. Then put the tube in your caulking gun, to squirt out the caulking compound. If you don't have a caulking gun, you can still push on the plate in the back of the tube, the opposite end from the one you sliced open, with the handle of a hammer. The caulking compound comes out, you put it where you want it, and smooth it into place, using a finger tip. Acrylic is perfectly safe to touch, because the solvent is just water. Silicone caulking compound (which uses acetic acid as a solvent) can give you a blister if you have excessive skin contact, so you would use something else than a bare finger tip.
Caulking :TO make metal to metal contact Fullering :To have rivet to part contact.
Silicone or latex caulking will it discolor the silver on mirror
Yes you can, but it is a cleaner job if you remove the old caulking (as much as you can) and reseal it with new caulk.
How salt dissolve in heat