AND thennnnnnnn, comprate UN relo
a device protecting conductors or other equipment in a circuit from an overload/overcurrent situation
Safety devices used in electrical circuits.AnswerA fuse is an overcurrent protection device, and will operate in the event of a sustained overload current or a short-circuit current.
Current is flow of electricity charge. Voltage is a measure of potential energy or charge. Fuse. Is a device that opens when the current rating is exceeded this stopping the flow of current.
A VERY BIG PROBLEM practically all electronics are restricted to voltages no greater 40 50 volts electrostatic can be as much as 5kv to 50 kv but the source impedance is very hi so while the voltage is there current capabilities are not a low impedance device can possibly survive these discharges but a hi impedance device like MOS cannot survive since the negligent current will raise the potential very hi blowing the device.
Fuses or circuit breakers are termed 'overcurrent protection devices', which protect circuits from either an overload current or a short-circuit current.
'Overcurrent protection devices' are used to protect conductors from excessive current flow... a fuse
a device protecting conductors or other equipment in a circuit from an overload/overcurrent situation
A: A current source can be defined as a zero impedance source. A battery is essentially a zero impedance since it can provide lots of current with zero volts out
breakers and fuses
The one with the highest resistance (or impedance, if the voltage is not DC).
Because the operation of the transistor is determined by the current at the base. the principle equations of BJT operation are: Ic = h*Ib ,and Ie=Ib+Ic thus device operation is controlled by the input current.
A: Its function is to trip if the current across it coil is its tripping pointAnswerA circuit breaker is an overcurrent protection device which can break a fault current.
Safety devices used in electrical circuits.AnswerA fuse is an overcurrent protection device, and will operate in the event of a sustained overload current or a short-circuit current.
By the rating of the overcurrent device.
An impedance matching device is used to test the resistance, inductive reactant and capacitive reactant in a circuit. If one component did not match the impedance of the conductor, some of the current will be lost by the conductors itself. In conclusion if electricity is lost, the component needs to meet its regular voltage. It consumes more voltage than expected because of the loss. Impedance matching device can actually reduce electrical cost.
A circuit breaker is an overcurrent device that can be reset after it has opened.
Current is flow of electricity charge. Voltage is a measure of potential energy or charge. Fuse. Is a device that opens when the current rating is exceeded this stopping the flow of current.