RELAXING THE BLOOD VESSELS, SO INCREASE THE SURFACE AREA FOR THE BLOOD TO EXPOSE AND REDUCE THE HEAT EFFECT
when its hot, the sweat keeps you cool. tiny blood vessels near the surface of the skin help to cool your blood.
eccrine sweat glands
The process of cooling off or stabilizing the body following perspiration is called thermoregulation. It allows the body to maintain its core internal temperature.
Sweat glands secrete water onto the surface of the skin. When this water evaporates it carries with it body heat, thus cooling the body and lowering temperature.
slower rates of cooling will create larger crystals, rapid cooling allows little time for element accumulation in the crystal, therefore, the crystals created will be smaller. larger, visible crystals in igneous rock indicate that the magma was slow cooling, usually at depth. much smaller crystals in igneous rock indicate rapid cooling of lava, usually at or near the surface. crystals in igneous rock will grow larger and have more to accumulate material for their growth the more they have at their crystallization temperature.
Batch sterilization uses steam or direct firing to elevate the temperature, and then cooling water stops the process and brings the material back toward room temperature. Both the heat and the cooling water are spent with no opportunity for energy recovery. Large volumes should be passed continuously through heat exchangers for energy economy with the hot, treated fluid heating the cold, incoming feed.
The scrotum is the structure that regulates the temperature of the testis. It contracts in the cold, drawing the testicles closer to the body increasing their warmth, and when it is warm it relaxes allowing the testicles to fall farther from the body, thus cooling them.
An example of an environmental control is a thermostat that regulates heating and cooling systems to maintain a desired temperature in a building.
Newton's law of cooling applies to objects that are both heating and cooling. Newton's Law of Cooling states that the rate of change of the temperature of an object is proportional to the difference between its own temperature and the temperature of its surroundings.
eccrine sweat glands
evaporation Cooling is a decrease of the temperature of a system or material.
I believe you mean the temperature at which water vapor condenses due to cooling. This is the dew point temperature.
newton's cooling constant is defined as the ratio b/w change in temperature and difference in temperature of hot body and temperature of surrounding
The engine temperature cooling switch helps regulate the engine's temperature. Teemed with the radiator and incoming air, this keeps the engine at its optimal performance temperature.
Chilling is the reduction in temperature of the required solvent below than its wet bulb temperature while the rest is considered as cooling i.e. if we are only reducing the temperature of solvent to an extent such that the final temperature is above its wet bulb temperature than it will be considered as COOLING.
Increase circulation and oil cooling. Not all Harleys have external tanks
Cooling.
The Approach is the difference between wet bulb temperature and outlet water temperature from cooling tower. That means , in this case, Approach = 35-25=10 degrees.
If a loss of ductility caused because of temperature, it will be temperature embrittlement. When welding, if cooling rate not controlled, it will leads to faster cooling(Martensitic zone) and will produce brittle structure which normally defined as temperature embritttlement.