area is a way of measuring size.
So a larger area should increase the power output
The larger the area surface of the solar cell the more energy output is made, because of it has more area so that it can intake more sunlight so therefore it can give more of its energy of more quickly.Most obviously the more sunlight intensity on the solar cell the more energy it given off because sunlight = energyso the more sunlight that has been inputed into the solar cell the more output energy will be given off.
It quantified in kW per area or kWh per area per day since the output of wind power is electricity.
To estimate the production of a wind turbine must be given the following factors: 1 - type of wind turbine 2 - wind speed in wind turbine installation 3 - angular velocity of turbine shaft 4 - an area of ​​wind turbine blades that are vacuum However, using the following formula can be produced by wind turbines can be estimated as: P = 0.5 * cp * ρ * A * V3 In the formula above: cp: Power Factor ρ: air density A: It is an area of ​​wind turbine that will sweep V: wind speed Is. The turbine can be calculated to consider the following points: 1 - the coefficient function of the ratio of the speed or the speed of EDGE is that it will display with λ, ie: cp = f (λ) But λ is a dimensionless number obtained from the following formula: λ = (Rω) / Vwind Where: R = length of wind turbine blades Vahdsh turbines and ω = angular velocity (rad / s)
The Power Generated by a Wind Turbine entirely depends on the capacity of the turbine which is installed.. there are turbines ranging from 1 watt to 10 MW that can be installed in a wind farm The installation of the turbine depends on the Wind Potential of the area.
Hydroelectricity is a method of producing electricity from flowing water. A large area of water - typically held behind a dam - is forced (by it's own weight) through a turbine generator, which makes the generator spin. When the generator spins, magnets attached to the turbine portion move past magnets mounted on the generator walls just outside the turbine. This produces electrical current, which is harnessed as electricity.
The surface area of mitochondria or chloroplast affect its energy output because larger surfaces-to-volume ratio imply more loss of energy as opposed to smaller surface-to-volume ratios.
increased surface area, increases output
The larger the area surface of the solar cell the more energy output is made, because of it has more area so that it can intake more sunlight so therefore it can give more of its energy of more quickly.Most obviously the more sunlight intensity on the solar cell the more energy it given off because sunlight = energyso the more sunlight that has been inputed into the solar cell the more output energy will be given off.
hhhj
It affects how warm the atmosphere is.
It affects how warm the atmosphere is.
It quantified in kW per area or kWh per area per day since the output of wind power is electricity.
The primary objective of a turbine is to create a large surface area for maximum contact with the force that drives it round, this could be air, steam, water ect. The more efficient the turbine is at this means that it will produce a constant amount of motive power. The turbine connected to a generator shaft (most likely by a gearing system) will then turn this motive power into mechanical power and in turn electrical energy from the generator. In theory the as a secondary objective the turbine could be used as a cooling function to dissipate some of the waste heat energy produced in the generator.
To estimate the production of a wind turbine must be given the following factors: 1 - type of wind turbine 2 - wind speed in wind turbine installation 3 - angular velocity of turbine shaft 4 - an area of ​​wind turbine blades that are vacuum However, using the following formula can be produced by wind turbines can be estimated as: P = 0.5 * cp * ρ * A * V3 In the formula above: cp: Power Factor ρ: air density A: It is an area of ​​wind turbine that will sweep V: wind speed Is. The turbine can be calculated to consider the following points: 1 - the coefficient function of the ratio of the speed or the speed of EDGE is that it will display with λ, ie: cp = f (λ) But λ is a dimensionless number obtained from the following formula: λ = (Rω) / Vwind Where: R = length of wind turbine blades Vahdsh turbines and ω = angular velocity (rad / s)
Time of day & cloud cover.
The energy created from a wind turbine is proportional to the formula for area of a circle which is pi x r^2. pi = 3.14159, and r=radius. this means that if the blades are twice the length of another wind turbine, there is a far greater amount of energy produced. Information courtesy of Centre for Alternative Technology, Wales. In general, wind turbines are a great way to go if there is sufficient wind as the energy is sustainable energy whereas other means such as coal burning are finite
The Power Generated by a Wind Turbine entirely depends on the capacity of the turbine which is installed.. there are turbines ranging from 1 watt to 10 MW that can be installed in a wind farm The installation of the turbine depends on the Wind Potential of the area.