0
After the engine warms up and the thermostat opens up, some of that heated antifreeze is directed through the heater coil. The MVAC fan blows air over it, and the heat transfers to that air, then it's directed through the ducts.
Wiki User
∙ 7y ago
Add your answer:
Earn +20 pts
Have a 1996 ford ranger 4 cylinder that occasionally runs hot and the heater does not work?
Check coolant level
Why won't the signal lights and heater fan work when you start your Ford Ranger?
Sounds to me like the turn signals and the heater fan may be on the same fuse?? Jack
Your blower does not work on your 1989 ford ranger?
Replace blower motor resistor usually located in the duct work or out in engine compartment in ductwork by heater motor.
Your 1991 ford ranger oil pressure gauge doesnt work what could be wrong?
Bad oil pressure sending unit?
Need diagram heater switch on 1995 Ford Ranger?
need help with a ford ranger the blower switch all been replace that there all work .but still no heat So told that there are a door that turn from Ac to Heat some where upon the dash .
What are the signs of a broken fan heater on a ford focus?
A broken fan heater can not work and A FORD Foucs does not run
Will 1994 Ford Ranger 3.0l fuel pump work in a 1992 Ford Ranger 4.0l?
Probably. As a mechanic, I would attempt it.
Will the manual trans from a 4-cylinder Ford Ranger bolt up to the bell housing of a 6-cylinder Ford Ranger?
I am converting a ford ranger automatic (a4ld) transmission 4wd to a 5 speed manual from a 4 cylinder ford ranger. Will it work. What is needed?
How do you replace a heater core in a Ford Ranger 3.0 L V6 automatic transmission 2WD?
youll need to pull the dash out, its a lot of work, then disconnect the heater core hoses under the hood and change it the put the whole dash back in
Which years of 5 speed transmission will work in your 93 ford ranger with 3.0 v6 and 2wd?
it will work in the ford
Heater is not working in a 2002 ford foucs only work when fan setting is place in?
Heater is not working in a 2002 ford foucs only work when fan setting is place in?
Can a 1988 Ford ranger standard transmition work in a 1992 Ford explorer?
I believe they are swithable if the ranger had the 2.9 V-6. (same mounts)
