0
What else can I help you with?
Where do wires go on 350 chevy mini starter?
The starter needs a large wire from the battery and a wire from the starter switch. These are connected to the solenoid that is attached to the starter.
What is the signal wire for MAF for a 94 Mazda protege?
need to know what wire go were for a 94 Mazda protege MAF sensor
Where is the battery located on a John Deere 2555?
Find the starter and follow the heavy gauge wire from the starter. It will go to the starter relay or battery. If it goes to the relay then follow the heavy wire from the relay which will go to the battery.
How do you wire a starter for a Pontiac 400 engine?
where do the wires on the starter go on a 1977 pontiac 400
Where does the purple wire from the starter go and what is its purpose?
The small purple wire on the "S" terminal of an older GM vehicle starter would lead to the ignition switch. With the key in the start (crank) position, the purple wire signals the starter solenoid to engage the starter.
How do you replace a starter for a 94 Ford Thunderbird?
go check in iraq, you commie. comprendo?
Why is there a little squeak when starting the engine on a 94 MPV?
see if starter is starting to go....
Where does the negative ground wire go on a dodge neon starter?
it goes from the starter mounting bolt to the battery box.
Where does the earth wire bulkhead go on a 94 Si fiesta?
up the exaust
94 civic ex wount start with the key but will start if i hot wire or bridge the starter i already replaced the main relay is their a seprate relay for the starter circut?
check the ignition module. you might have to take apart the steering colum so i would go get a Chilton manual
What side of the starter does the wire that comes from the alternator go to positive or negative?
Positive
How do you wire a starter for a go kart?
To wire a starter for a go-kart, first, connect the battery's positive terminal to the starter's positive terminal using a suitable gauge wire. Then, connect the starter's negative terminal to the go-kart's frame or battery's negative terminal for grounding. Use a push-button switch or ignition switch to connect from the battery's positive terminal to the starter solenoid, allowing the starter to engage when the button is pressed. Finally, ensure all connections are secure and insulated to prevent short circuits.
