answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How elevator work open loop or close loop?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does the close door button on a Otis elevator work?

No, it doesn't. I was told that it was for people that have OCD so that they would feel better.


How do you close a faction in Minecraft?

For most multiplayer servers, to close a faction, you say, "/f close". If you want to open it again, say, "/f open". This will only work if you are the faction leader.


How do a cars manual windows work?

They have a crank handle on them that you turn to open or close.


How do you use sissciors?

You open and close the handles as you move the blade through the work.


What time does Hardee's close?

I work at a Hardees and were open all day on Thanksgiving


How does an elevator work?

what you do is you go into the elevator, with another person on the outside. you grabve there under wear, quickly close the elevator doors, and click the button to go tot he highest floor. keeping tight grasp on the person's underwear, wait until you are at the top floor. then let go. and get off the elevator, take the stairs don, and check out the person. the friction of you holding on to there under wear should have lifted and ket the on the top of the elevator doors. and the only way to get them down is to ride the elevator down, if the gerson's underwear has. if already ripped.


Why digital camera is an example of an close loop control system?

I dont know hello i no nothing about this but i think the work because its made out of baterys and well its digital


How do you use a trapdoor in minecraft?

right click to open/close it will also work with redstone.


How to you be close to your family?

be open and honest if u have a problem with a family member try and work it out


What is open loop and close loop system?

Q: What is the difference between 'Open Loop' and 'Closed Loop'? A: When the engine is first started, and rpm is above 400 rpm, the system goes into 'Open Loop' operation. In 'Open Loop', the ECM will ignore the signal from the Oxygen (O2) sensor and calculate the air/fuel ratio based on inputs from the coolant and MAF sensors, but mostly from a pre-programmed table in the memcal. The system will stay in 'Open Loop' until the following conditions are met: 1. The O2 sensor has varying voltage output, showing that it is hot enough to operate properly. (This depends on temperature) 2. The coolant sensor is above a specified temperature about 40oC/104oF. 3. A specific amount of time has elapsed after starting the engine. The specific values for the above conditions vary with different engines and are stored in the mem-cal. When these conditions are met, the system goes into 'Closed Loop' operation. In 'Closed Loop', the ECM will calculate the air/fuel ratio (injector on-time) based on the various sensors but mainly the O2 sensor. This allows the air/fuel ratio to stay very close to 14.7:1.


How does a microwaveoven work?

weeelll you open the door and you close it and then you put how long you want it to cook then you wait for it to stop open the door and eat it


How does an elevator wedgie work?

what you do is you go into the elevator, with another person on the outside. you grabve there under wear, quickly close the elevator doors, and click the button to go tot he highest floor. keeping tight grasp on the person's underwear, wait until you are at the top floor. then let go. and get off the elevator, take the stairs don, and check out the person. the friction of you holding on to there under wear should have lifted and ket the on the top of the elevator doors. and the only way to get them down is to ride the elevator down, if the gerson's underwear has. if already ripped.