0
What else can I help you with?
What hole does a wire have to go in when installing a single gang box on a 2X4 stud wall?
The wire should go through the knockouts located at the back or sides of the single gang box when installing it on a 2x4 stud wall. The knockouts can be removed with a screwdriver or pliers to create an opening for the wire to pass through.
How many romex wires can you put undet a staple?
It depends on size of wire and size of staple. a staple 1/2 inch long can hold 1 10-2 wire, 1 12-2 or 12-3 wire, or 2 14-2 or14-3 wires. basically the bigger the staple the more wires. Just be careful not to hammer the staple into the wire. You want the staple snug but not biting into the wire.
How do you wire a single switch as a break in a series not in a gang box?
This question needs more explanation of answer needed
What type of prewire for a ceiling fan light?
The pre wire for a ceiling fan light should be made with a three wire cable. This cable will have a red, black, and white wire as main conductors. This cable will also have a bare ground wire. This wire should be strung between a two gang switch box to the fixture junction box. This pre wire allows the supply to be either fed to the two gang box. From the two gang switch junction box, one side will be used for the light in the fixture and the other side of the switch junction box, itwill be used for the fan portionin the fixture.
How can I properly wire a 2 gang switch for controlling multiple lights in a single circuit?
To properly wire a 2 gang switch for controlling multiple lights in a single circuit, you will need to connect the hot wire from the power source to the common terminal of each switch. Then, connect the hot wire from each light to the corresponding switch's load terminal. Finally, connect all the neutral wires together and all the ground wires together. Make sure to follow proper safety precautions and consult a professional if needed.
Stapling romex wire?
Close to a box to prevent rubbing/wearing of the insulation. Do not drive the staple so tight that the wire cannot move; if the wire is too tight it may flatten and overheat under the staple, increasing the potential for fire.
Can a single duplex receptical be wired for 120 volts and a second single duplex receptical be wired for 220 volts if they both reside in the same two gang electrical box?
Yes, the feeder will have to be a three wire cable.
How do you test the fuel-pump on1999 silverado truck?
There should be a single wire with a green connector on the end located by the master cylinder. put 12 volts to that wire and the fuel pump should run
How big of a single pole breaker can you put on 12-2 wire?
In general, you should never use a breaker larger than 20 Amps on a #12 AWG (American Wire Gauge) copper wire.
What are the wire colors for a single phase 30 amp 220 plug?
The hot wires are red and black. White is the neutral, and there should be a bare or greencolored wire for grounding.
What wire do you unplug to time 98 Chevy 5.7 with a timing light?
There should be a single wire hanging below the glove box. disconnect to time. dont forget to reconnect
Another name of single strand wire?
Another name that can be used for a single-strand wire is thread or strand.
