0
I have gas coming out the tailpipes and also when I took out the #8 spark plug gas poured out . Dose anyone have an answer for my problem?
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What if misfire is not plugs or wires on 99 Chevy Tahoe?
Ck your injectors, may have one failing
How to unclog injectors on a 99 Tahoe?
It is important to have functioning fuel injectors. A person can unclog their fuel injectors by buying fuel injector cleaner and putting it in their gas tank every time it almost empty.
At what mileage do you change a 1998 Chevy Tahoe timing chain?
at what mileage do you change a 99 Chevy Tahoe timing chain.
How do you change the fuel injectors on your 99 olds alero 3.4 liter?
There are many little steps when removing the injectors, I would recomend a haynes manual. It's not hard to do, but better if you have the pics in the book to go by.
How do you change a lower ball joint that is pressed in?
how do i change lower ball joint that is pressed in on a 99 tahoe
How do you change door pins and bushings on 1999 Tahoe?
Look here http://www.hotrodders.com/forum/99-tahoe-door-pins-136678.html
How many quarts of transmission fluid does a 99 Chevy Tahoe need after a filter change?
125 quarts
How much freon does a 99 Tahoe with rear ac hold?
How much freon does 99 Tahoe with rear ac hold
Can you install a carborator on a 99 Chevy Tahoe will there be a problem from the wiring or computer?
NO you can not, won't work, engine won't run.
What should the idle be set for a 1999 Chevy Tahoe?
idle speed for a 99 Tahoe
How much is a thermostat on a 99 Tahoe?
About $ 10.00
Are replaceing fuel injectors on a 1999 5.7 Suburban difficult for a non-mechanic?
i own a 99 Tahoe with the 5.7 i recently replaced head gaskets and the fuel injectors are not to bad to change with a little patience they are located under the plastic plentum that's bolted to the top of the intake dealing with the monster wiring harness is the worst part once you get the plentum off the injectors pop right out i would suggest a chilton manuel and a basic tool set and a hour or two should be all it takes.
