It's not hard, it's very easy.
remove the glove compartment you'll see it.
Diagram for location of blower motor resistor can be found herehttp://autorepair.about.com/library/images/bl441a-lib.htm
Replace the blower motor resistor block. It is located under the dash on the passenger side.
The blower motors only work with the engine running. If the blower motor has three wires on the electrical plug, then the blower motor module is built into the unit & it's very expensive. Sometimes, you can tap on the motor with a hammer & it may work or slowly turn. If this is the case, replace the blower motor.
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
it should be next to the blower motor
might need to replace blower motor
You must remove the glove compartment door to access the blower motor. On top of the blower motor will be wires connecting to the top. Release the connecter and let it dangle. Then using a screwdriver, remove the blower resistor on top, where the wires connected, and replace with a new resistor.
The blower motor can be replaced on a 1995 Chevy truck by first disconnecting the battery. It helps to take a picture of the blower motor before dismantling, so that it can be put back easily. Disconnect all the wires from the motor, then remove the bolts holding it to the firewall. Replace with the new motor and bolt it in, then connect the wires. Reconnect the battery.
fuse, wiring, blower motor, blower motor switch, blower motor resistor
you can try search at this site for free: http://pdftown.com http://free-pdf-ebook.com
Blower motor is under the dash on the passenger side.