0
soz i dunno
It is hard on the electricity even if not heated since you still have to run the pump constantly plus the chemicals.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What happens to Coyotito at the little water pool in the high desert in the book The Pearl?
In the little water pool, in the high deserts, the guards kill Coyotito with a shotgun, in the head.
Pool store said you should change the pool water even though it is clear should you?
if its a kiddy pool yes. If its an inground pool or a large above ground liner pool, no Take a sample of your water to a pool store you trust. Ask them to test "TDS and calcium hardness" If they are high then you probably need to change some or all of your water. Be aware it's DANGEROUS to drain pools if your water table is high or when the ambient temp is high.
Why won't my pool water clear up?
You may have a high metal content in the water you are using to fill the pool. Check the metal content of the water.
Add acid in pool?
acid is added to a pool when alkalinity is too high. Take a sample of pool water to your pool shop and have it tested by them. they will tell you what is required.
Can air get into pool filter causing it to lose prime if water level in pool is too high?
Yes, air can get into the pool pump causing it to lose prime if you have a leak or crack in the plumbing leading from the pool to the pump. The pool level being too high plays no role, however you should make sure that the pool level is not too high for other reasons, mainly the level is too high, water will leak under your cement causing it to settle. Keep the water level in the middle of the skimmer opening.
Is high pH levels in pool harmful?
High Ph or high alkalinity in pool water makes the water "hard" and leads to "scaling" or calcium buildup on pool walls and equipment. Over a long period, alkaline water can be harmful to equipment and create a film of calcification on tile or pool walls. As far as harm to people, high Ph makes the water feel "slimey" and it is easier to slip on steps or the floor of the pool. It can dry out skin and feel ichy. In contrast to high acidity- high alkalinity seems to cause less skin discomfort. Each pool is an ecosystem and needs to find a balance...one person's pool could be in fine balance at 7.8 while another is better at 7.2
How do you raise the cyanuric acid level in pool water?
Remove some water in container (10-20%) and add new water. example: pump water high in cyanuric acid out of a swimming pool and the add fresh water to the pool.
Should you drain the water when swimming pool is not in use?
No, then you have to refill it and that is a waste of water If it is an inground pool being dry will ruin the pool surface and in high water table areas the risk of turning it into a boat is very real.
Rain is filling the pool and water is too high?
Count your blessings, free water. If you have a salt water pool you are better of hanging on to it because if you dump you weaken the salt in the pool. If you feel that you need to have the skimmer working properly which is important in keeping pools clean you could get a floating pool skimmer which will work whether the water is high or low. Regardless of what you do evaporation will soon bring the water level down again.
How many cm high in water can a 12ftx30inch pool hold?
A pool that is known for being 12 feet x 30 inches can hold 73.2 cm high of water. This type of pool is commonly used above ground and often contains a metal surround.
Is high chlorinated pool water harmful to you?
Yes, the chlorine will burn your skin
With existing inground pool what is best to get rid of underground water due to high water table?
If you intend to empty the pool with high water table problems you would be wise to dig down next to the pool until you are level with the bottom and get a submersible pump down there big enough to keep up with the influx of water until you are finished what you are intending to do.
