130 to 180 feet in the air
The correct spelling is "geyser" (a spout or eruption of water).
Geysers like "Old Faithful" and "Steamboat" in Yellowstone are natural hot springs and the area is a permanent magma "hot spot." Due to the close proximity of the water therein to the magma under the Earth's surface, the water feeding the springs gets hot enough to boil in large quantities, causing steam to burst upwards through the Earth's crust. If a tea kettle was the hollow area of a hot spring, the spout would be the geyser. Imagine the heat of a stove as the heat from the Earth's magma; eventually the water gets hot enough to boil and the steam shoots out of the spout.
Yes, a geyser is natural. A geyser requires three critical elements in order to form: a water supply, a heat source, and the proper kind of underground water circulation system.
The whales spout water every so often. The water spout is clogged.
The spout on a teapot is commonly referred to simply as the "spout." It is the part of the teapot designed for pouring tea from the vessel. Some teapots may also have a "spout lip" or "spout tip," which refers to the end of the spout that directs the flow of liquid.
To fix a diverter tub spout, you can start by removing the spout and checking for any blockages or debris. Clean the spout and the pipe it connects to, then reattach the spout securely. If the issue persists, you may need to replace the diverter valve inside the spout.
the SPOUT .
A spout is a tube or lip through which liquid is poured.
no, it does not flow out of the spout eaisly
No. They blow their breath out of the spout.
It depends what spout you are talking about. If you are talking about a whale spout they can get up to thirteen centimetres long and twenty centimetres wide. If you are talking about a spout from a fountain or drinking tap it can get as big as you want.
To replace the spout on your water jug, first, remove the old spout by unscrewing it or pulling it off. Then, insert the new spout into the opening and secure it in place according to the manufacturer's instructions. Make sure the spout is tightly sealed to prevent leaks.