0
How hot does the metal have to be for it to work in a bullet mold?
Wiki User
∙ 10y ago
The metal would need to be past its melting point to work in a bullet mold. For example, if the metal was stainless steel, the temperature is 1510 degrees Celsius.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is lost cast waxing?
Lost wax casting. You make something out of wax, jewelry or something similar and attach one or more strips that will act like tubes when the wax is melted out of the mold. You put the piece in a metal container of the right size and pour plaster around it. After the plaster sets, you heat it so that the wax will run out. After this, you melt metal, gold or silver and pour it in the mold or there is a centrifugal caster that forces the molten metal into the mold and gives a better casting. With the mold hot from melting the wax out and the hot metal, you put it in water and the plaster blow off of the piece.
What is lost-wax cast?
Lost wax casting. You make something out of wax, jewelry or something similar and attach one or more strips that will act like tubes when the wax is melted out of the mold. You put the piece in a metal container of the right size and pour plaster around it. After the plaster sets, you heat it so that the wax will run out. After this, you melt metal, gold or silver and pour it in the mold or there is a centrifugal caster that forces the molten metal into the mold and gives a better casting. With the mold hot from melting the wax out and the hot metal, you put it in water and the plaster blow off of the piece.
How do you make vinyl toys?
Vinyl toys are made using a hot rubber or plastic substance and a mold. The hot rubber is pumped into a mold. The mold has all of the air sucked out of it by a vacuum. When the hot rubber is cool, the mold opens and the vinyl toy can be taken out.
Metal lids on glass jars can often be loosened by running hot water over them. Why does that work?
The metal expands a bit.
Will a bullet in a fire go off?
No- but a CARTRIDGE can. The bullet is the solid metal part of a cartridge that comes out of the end of the barrel. Being solid metal, there is no part of it that is flammable or explosive. A CARTRIDGE is an entire. loaded round of ammunition (Cartridge case, primer, powder, and bullet) If those are in a fire and get hot enough, they will explode. However, when not confined in a gun barrel, the energy is not directed, and pieces of the case or bullet will usually only travel a few feet.
Can hot glue a metal bolt with hot glue?
Hot glue won't really work to hold a bolt in place with any strength.
Do hot dogs mold?
They are molded with an outside wrap.
On a ceramic butter mold how do you put the butter in so it will come out easily?
Run hot water on the out side of the dish. If that dosent work, try a spoon :P
When was Hot Metal Bridge created?
Hot Metal Bridge was created in 1887.
When was Hot Metal created?
Hot Metal was created on 1986-02-16.
When did Hot Metal end?
Hot Metal ended on 1989-03-10.
What is a vacuum mold?
A vacuum mold is a shape that is placed in a vacuum molding machine to produce the finished piece. A hot plastic sheet is lowered onto the mold, and then air is vacuumed out from underneath. This pulls the soft plastic sheet down over the mold, and the plastic takes the shape of that mold. Cold air is blown over the setup for a short time, and the molded plastic sheet, with its molded shape formed in it, is lifted off the mold and sent on for further work.
