Not on the clutch itself but on the clutch pedal there is one for starting.
bleed clutch Saturn vue 2003
You cannot adjust the clutch on the s-series.
ok here we go i called the dealer and they wanted $1200.00 2 put the clutch in my 96 SL2.so i did it my self with out taking the tranny out.i bought the clutch for $250.00 and 4 hours of time.you can do ityourself if your inclined.Here's the thing cut the clutch tool in half that comes with the clutch.And Now install the clutch.
S-series use self adjusting clutch hydraulics. You cannot adjust them
It's a self adjusting hydraulic clutch. If it needs adjustment, it's probably either a bad clutch or a faulty clutch master or slave cylinder.
how do you bleed a cluch on a 92 Saturn sl
How long after you had it fixed
autozone will do it for you for free.
Below the brake master cylinder and to the left (drivers side) of the vehicle.
Most likely yes the pressure plate is failing or the release bearing
How to fold down rear seats in 1998 Saturn
Yes, it's inside the fuse/relay panel.
My son's 1999 Salvaged/total Saturn SL1 was rebuilt using many engine and body parts from 1995-1999 Saturn SL1 and SL2 cars, I believe it will work fine. I do not recommend before 1995 or 2000 or later models. I do not recommend SL2 either. I am not the expert but most of my son's engine is not 1999 SL1. Good luck!
check link below: http://www.youtube.com/watch?v=h1kaUA3U7u4
1100 at the dealer. expect 800 at a local mechanic
what is the engine diagnostic trouble code # 32
When the clutch pedal changes position, it usually indicates the need for a new clutch...but... You should be able to find a shop manual at your local library with the right info...make copies as they are usually only in the REFERENCE section....good luck:)
yOU CAN'T....iT'S HYDRAULIC. If it's releasing high you need a clutch.If it's low you need a hydraulic unit
Your best bet is to pay the $15 for a Chilton manual or go to the dealer for this type of question. I have the same problem on my 1998 SL1. The dealer said $1,200 and another non-dealer shop said $1,100. I said I will check out my Chilton manual. It seems very involved just to replace a gasket. But most of the work is done from top.
Yes it will.
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
on my 94 it was near the oil filter and it was a canister type like your oil filter
You probably have a bad coolant temperature switch, this are fairly cheap and easy to install.
sounds like you need a new alternator or have a grounding issue somewhere