It helps us to select the Q - point of the BJT, MOSFET etc.
supposed to be MOSFET. but i also depends on your working freq.
what is the function of IRFZ44
amplifierswitch: digital or powerchoppermodulatoretc.
3 or 4
It helps us to select the Q - point of the BJT, MOSFET etc.
Use a mosfet driver instead of a simple resistor. Using a resistor to control the mosfet is a bad idea anyways because you will have terrible control (mosfets are voltage controlled. Take a look at the response curve for your mosfet). If your mosfet is fully on, its ratings may be too low for continuous operation or the power dissipation is too low for the transition between off an on an that is killing your mosfet.
what is a mosfet amplifier
MOSFET is an acronym standing for Metal Oxide Semiconductor Field Effect Transistor.
not yet
It depends. A depletion MOSFET can be used as an ehancemnet MOSFET when it is operated as an analog amplifier. However, a depletion MOSFET can't replace an enhancement MOSFET when it is operated as a digital switch. When a depletion MOSFET is used as a digital switch, since the junction between source terminal and substrate must be reverse biased, the voltage of the source terminal of an N typde transistor must be tied to Vdd, and it is completely opposite to an enhancement MOSFET. When a depletion MOSFET is used as an analog amplifer, the source terminal and the substrate are both at the same potential, just like an enhancement MOSFET.
mosfet base power inverter of advantages and disaadvantages
Depletion mode MOSFET is normally on device --vlsijp
In simple MOSFET current mirror, the load current does not follow a linear relationship with reference current (ie for short channel MOSFET's multiplying factor due to channel length modulation cannot be neglected). But by cascoding the output resistance can be increased and since output resistance follows an inverse relationship with lambda (channel-length modulation parameter), the multiplying factor due to channel length modulation reduces to one and a linear relationship is obtained between reference and load current.
conductiong channels
Of course it is possible to make an inverter with a p-MOSFET!
Advantages:- 1- mosfet are small compare to bjt's so it fabricated easily and space saving scheme on the ic's 2- mosfet's input impedance are very high so they do not load the circuits. loading effect doesn't arise. 3- operating frequency is very high so may be used at higher frequencies. 4- used in digital circuits for it's reliability. 5- effect of noise is less than bjt. so high signal to noise ratio. 6-mosfets are unipolar devices so reverse saturation current doesn't exist. 7- it consume less D.C power rather than BJT. Disadvantages:- handling is not easy- Mosfet is very sensitive to electrostatic charge so it may be destroy when you touch the pins of a mosfet devices by hand. trans conductance is low than BJT.