It depends on what you are measuring! Distance is measured in metres Time is measured in seconds Mass is measured in kilogrammes Volume is measured in litres Force is measured in newtons Energy is measured in joules Temperature is measured in kelvin Power is measured in watts Electromotive force is measured in volts Electric current is measured in amperes ...and so on
Cup is measured by volume. It is measured in ml.
they are measured by................
It can be measured by volume
Mass is measured on anything it can be measured on so it cant be
CPU
Erin measured each board
rain is measured with a rain gauge but i have no idea what a snow board is :)
From the end of the takeoff board to the point in the pit closest to the board where the jumper touches the sand. If a jumper falls back with their hands, that is the point at which the jump is measured.
it should be mounted at a height not exceeding 2.25 meters measured from the floor to the top of the surface of the board or 1.4 meters to the bottom of the board from the floor
The long jump is measured from the front of the jump board to the closes point in the sand that the jumper touches the sand in a straight line.
A 2x12x12 foot board would not be measured in square feet but cubic feet and there would be 240 feet3
Current is measured in a series circuit by the use of a multimeter. First, the power source must be attached to the circuit board. The board is attached to the multimeter, then that is attached back to the power source.AnswerCurrent is measured either with an ammeter, or with a multimeter set to measure current. The instrument must be connected in series with the other components in the circuit.
From the throwing line to the surface of the board 2,37m (measured parallel to the ground). The height of the bullseye 1,73m.
chair meter stick adult's leg length of a classroom white board
then he must have to do that thing all over again as if one thing will be wrong all process will be wrong - - - - - It depends on a few things. If it's one board and the measurement is too long, you can cut the board again. If it's one board and the measurement is too short, the board can't be used in that place. This doesn't mean the board is bad, just that it won't fit where you wanted to put it. You can save that board and use it somewhere else. If it's a large area you measured wrong, the effect depends on how you measured it wrong. This is why we always measure twice.
Lineal foot can be measured on the ground. It is related to an actual measurement. Linear foot is a distance not necessarily measured along the ground. Also linear foot can refer to board feet.