Ways to reduce electrical resistance: increase the diameter of the conductor, decrease or increase the temperature of conductor (depending on its thermal characteristics), decrease the length of the conductor. A change in the material out of which the conductor is made can decrease resistance, too. And there is the phenomenon of superconductivity.
In a simple circuit the resistance can be lowered by adding resistors in parallel. The total circuit resistance will then decrease. You can also reduce resistance by substituting resistors of lower value, or by adjusting a potentiometer, or pot, to a lower value.
an ohm meter OR multimeter is used to measure the electrical resistance...
electrical resistance was discovered by Georg Ohm in the late 1820's.
Rheostat is the name of an instrument used to vary electrical resistance.
Based on the simplest Electrical Equation V = I * R,(reads: voltage equals current multiplied by resistance)then, rearranged I = V / R .As resistance decreases, current flow proportionately increases
electrical resistance increases current flow decreases.so to know the current flow in the network ,electrical resistance is required.AnswerResistivity is important, because it is one of the three factors that affect the resistance of a material. The other factors are the length and cross-sectional area of the material.
It will decrease the voltage drop.
Silicon because it is an intrinsic semiconductor.
if the resistance is decreased and the current stays the same, then the power decreases.
an ohm meter OR multimeter is used to measure the electrical resistance...
Resistance, or electrical resistanceResistance, or electrical resistanceResistance, or electrical resistanceResistance, or electrical resistance
Anemia
electrical resistance was discovered by Georg Ohm in the late 1820's.
Electrical resistance is measured in Ohms.
resistance is inversily proportional to squaire of radius of wire.
Conductors have a (low) Electrical resistance.
High resistance means insulation
Rheostat is the name of an instrument used to vary electrical resistance.