I am sorry but the question is not answerable, the question makes no sense.
I am going to recommend you read the very good WIkipedia article though.
To adjust the idle speed for a Slant Six engine, first ensure the engine is at operating temperature. Locate the idle speed screw on the carburetor and use a screwdriver to turn it clockwise to increase the idle speed or counterclockwise to decrease it. Ideally, the idle speed should be set between 600 to 800 RPM, depending on the specific model and condition of the engine. After adjustments, double-check the idle speed with a tachometer for accuracy.
The 2010 Chevrolet Camaro offers two engine options: a 3.6-liter V6 engine producing 304 horsepower and a more powerful 6.2-liter V8 engine with 426 horsepower in the SS trim. The V6 is paired with either a six-speed manual or six-speed automatic transmission, while the SS features a six-speed manual or an optional six-speed automatic. Both engines provide a blend of performance and fuel efficiency, catering to different driving preferences.
Increases the user's Speed by two stages. You have a max of six stages you can increase a stat. Each stage is a 50% increase so Rock Polish gives 100% increase to speed everytime you use it.
The power of the engine and the maximum speed of the 1965 Truck Dodge D-400 Motor Slant six 6cyl are 110 hp and 75 mph respectively.
It is hiding underneath the air filter box on drivers side of engine (uk)
2JZ-GTE Alone 594 lbs+ Getrag Six Speed 746lbs
They didn't have a 135hp six cylinder engine in 1977. They had a 134hp V8 that had a top speed of 107.
the input speed sensor is on top of the transaxle, about six inches from the engine, and directly in line with the engine. there is a technical service bulletin from Hyundai (#05-40-011 [aug. '05]) about input speed sensor problems, including dtc (diagnostic trouble code) p0715. trouble with the input speed sensor will make for some funky shifting, so if the engine revving to about 5000 rpms before the transaxle shifts out of 1st gear makes you smile, then don't replace the sensor. but if you want your car to run well.....wait, all you asked was where the speed sensor was, so....the input speed sensor is on top of the transaxle, about six inches from the engine, and directly in line with the engine.the engine speed up car goes faster but never shifts
Yes it will with no problems.
the input speed sensor is on top of the transaxle, about six inches from the engine, and directly in line with the engine. there is a technical service bulletin from Hyundai (#05-40-011 [aug. '05]) about input speed sensor problems, including dtc (diagnostic trouble code) p0715. trouble with the input speed sensor will make for some funky shifting, so if the engine revving to about 5000 rpms before the transaxle shifts out of 1st gear makes you smile, then don't replace the sensor. but if you want your car to run well.....wait, all you asked was where the speed sensor was, so....the input speed sensor is on top of the transaxle, about six inches from the engine, and directly in line with the engine.the engine speed up car goes faster but never shifts
With the straight six 250 ci engine and 3 speed manual trans, 95 mph.Same car with the 2 speed auto trans, 93 mph. With the 350 or 400 ci V-8 engine and auto trans, 108 mph. With the 454 ci engine and auto trans, 127 mph.
will a 1956 gmc 3 speed trans bolt on a chevy 350 v-8 engine