answersLogoWhite

0

How is radiator secured in on bracket?

Updated: 9/27/2023
User Avatar

Wiki User

6y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How is radiator secured in on bracket?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is your gps unit properly secured to its gps bracket?

Yes my gps unit is properly secured to its bracket. I followed the correct instructions that were included during my purchase and everything works fine.


How much weight can a ceiling bracket hold?

The weight a ceiling bracket can hold depends on the type of bracket and where it is placed. A solid metal bracket secured into a ceiling joist can hold quite a lot of weight. A smaller, weaker bracket or one that is secured only into sheet rock should only hold about a pound. A bracket that expands after installation should be used when not securing to a joist for heavier loads. Otherwise, the bracket may break or pull through the sheetrock. Check the bracket packaging for weight limits on the bracket itself.


The bracket that holds the radiator and condenser is called?

judicial &legislative


Where is the thermostat located on a 1997 Ford F-250 power-stroke?

follow the top radiator hose from the radiator to the top of the engine. the bracket (for lack of a better term, I'm not sure what the technical word for it is) that the radiator hose is connected to on the top of the engine is the thermostat's location. it's located under that bracket. two bolts hold that bracket on.


What is the proper gap for the spark plugs on a 1989 Chevrolet Caviler?

35 and it should say it right on the radiator support bracket, but I could be wrong. I think it's 35 and it should say it on the radiator support bracket, but it could be 45.


Where is the radiator fan relay fuse in a 1988 Chevy Celibrity?

The fan relay and its fuse are on the radiator support bracket on the right side of the car.


How do you change a radiator in a mk 3 vw golf?

you have to take the hole front end out bumper headlights radiator support bracket lots of parts


What is the name of the hose that connects to the air intake to the radiator?

No hose connects from the air intake to the radiator. It may connect to a bracket mounted not the radiator but it does not connect to the coolant. If that is what you are stalking about it is called an air intake tube.


Where is the starter on a 2.7 Chrysler Sebring convertible?

It is on the radiator side of the engine, behind the motor mount bracket.


Where is the starter on a 1992 Chrysler Town and Country?

It is on the radiator side of the engine, behind the motor mount bracket.


How do you install a winch to your polaris explorer?

you have to buy a mounting plate that is attached to the radiator bracket then attach the winch


How do you put in a radiator for Kia sephia?

there are four hoses hooked up to the radiator (two for transmission fluid and two for the antifreeze upper and lower). disconnect all of them. two nuts holding the top bracket in for the radiator take them off and disconnect the radiator fans. then just pull out the radiator.