Looking at the end of the solonoid on top of the starter, the battery cable hooks to the larger stud on the top "12 o'clock". A smaller purple wire connects to the smaller termanal at 3 o'clock and the stud at 6 o'clock connects to the flat wire comming out of the starter. The purple wire comes from the neutral/park safety switch, which is fed by a yellow wire comming from the start relay which is fed by a yellow wire comming from the ignition. The start relay is also controled by the Pass Key decoder module. , DAVID
Where does the camsensor go on a 1997 buick lesabre
Yes all cars do. Usually multiple wires.
To remove the starter on a 1997 Buick LeSabre, first disconnect the negative battery cable to prevent electrical shorts. Then, locate the starter, which is typically mounted on the engine near the transmission. Remove the electrical connections from the starter, followed by the mounting bolts securing it to the engine. Finally, carefully pull the starter out of its position and replace it if necessary.
how do you replace the fuel pump on a 1997 buick lesabre
The P0336 fault code on 1997 Buick Lesabre is a fault in the crankshaft position sensor circuit.
probably. go for it.
The 1997 Buick LeSabre is a mid-sized four door sedan. The vehicle retails for about 1000 dollars to about 6000 dollars depending on condition.
How do you uninstall a starter for a 1997 Buick Park Avenue
1997, 98 and 99 lesabres are supposed to bigger inside so check with a dealer or wrecking yard.
118 ft lbs 1997-2004 Buick LeSabre
5.25"
4