Want this question answered?
A burner is the part of the boiler that creates and controls the flame that heats the water. If you meant difference between a boiler and a furnace, a boiler makes hot water and a furnace makes hot air.
Pilot light would work but the main burner would not as the thermocouple proves that there is a pilot light to fire. The main gas valve would not open
An air blast burner is a burner where a controlled blast of air is supplied the gas. The burner has an air blast type fuel injector.
Oil burner magic!!
The most comon way to detect a crack in a heat exchanger is with a visual inspection, removal of the burner assembly and the use of a mirror and flash light. Or a smoke bomb test. A special little smoke bomb is placed in the burner area with the burners OFF. The blower is runnig and you light the smoke bomb, the smoke will draft up the flue vent or if a crack or rust hole is present then the smoke will get sucked into the air stream and come out of the duct work. Other than that using a carbon monoxide detector to see what the CO levels of the furnace are and comparing them to the supply air of the furnace to verify that there is no CO present in the air stream. The best and most accurate way is to contact a local Heating and Air Conditioning specialist or your local gas company should come out and perform a CO test on the furnace. Good Luck and God BLess
yes it can fan
That depends on what the burner is installed in. One particular burner can be used on a multitude of boilers/furnaces simply by changing the nozzle to regulate both gph and flame pattern to suit the application. Contact the boiler/furnace mfr or check the installation/operation manual for the boiler/furnace for help. Lastly if that is of no help or not possible a good oil burner mechanic could help you out once he sees your entire application.
Furnace, boiler, burner, cinerarium, cinerator, crematory, heater, heating system, oil burner, pyre
A furnace or a burner.
Unbolt the burner and slide it out of the way.
The hose go to inlet of gas fuel in the burner.
You sould be able to see it either in the open or through a sight glass. If you have a continious pilot you just look at the burner where the furnace is open. Higher efficiency furnaces have an intermitent pilot that is only light when it is needed to light the main burner. And some do not have pilots at all and an ignightor lights the burner directly.
I think that can be found on a website called HowStuffWorks.
A log burner if it is gas, should be installed professionally by a plumber or contractor who could run the gas lines to the furnace. If it is a wooden log burner than home depot and lowes are good choices.
It would depend on the type of burner in your oil furnace and the type of jet fuel. I recommend that you contact the manufacturer of your furnace first.
An oil fired furnace works by using oil and a flame. The oil is sent through a tube to the burner area of the furnace and when the oil is ignited with a lighter, the flame can be adjusted according to how much heat is necessary.
Make sure you press reset button on oil burner longer than forty seconds because that is the manufacturers way of idiot-proofing the furnace against the homeowner.