Different lengths depending on your transmission in your vehicle, get a tape measure and measure it. It also depends on if your vehicle is a 2 or 4 door.... Different wheelbases....
18' and some odd inches.
It was the same as a chevelle, approx 16 feet long.
You can but you will have to change or alter the drive shaft also.
there is no front shaft in 63 impala Wrong answer, it's about two feet from the transmission to the carrier bearing
64 chevelle is 16 feet
It depends on if it is two or four wheel drive, a 4x4 is 48 inches
driveshafts are all differen't lengths depending on the type of rear drive vehicle you have and the type of tranny that is in it.
Ok the shaft drive is smoother as long as the shaft and bearings are maintained properly the belt drive will be close to the same smoothness but will have a slight vibration due to the design of the pulley teeth or cog and the belt tooth contact area. and the belt needs adjustments more often. hope that helps
There is a square tag that is about 2 inches high and 4 inches long on the top of the firewall just to the right of the master cylinder.
about 36 inches w/ 5 sp manual
If you cut the housing down to fit the chevelle it will work but to just take and try to put it under the chevelle it's too long.
Long shaft