0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
When induction motor is switched on the rotor frequency is?
The induction motor rotor has different frequency compared to it's stator. The rotor has slip ( s ) frequency. slip = ( Synchronous speed - rotor speed ) / Synchronous speed Synchronous speed = ( 120 * f ) / P where f = supply frequency to the stator. p = no of poles rotor speed is the actual speed the motor is running. Frequency in the rotor = slip * frequency in the stator At starting rotor speed is zero, so slip is one. Let us take the supply frequency is 50 Hz, then rotor frequency is also 50 Hz at starting. The motor attains speed and runs with its full speed at a point of time. Then let us take the slip is 0.04 then the rotor frequency will be 2 Hz.
P-trap replacement metal drain pipe from wall has swivel flange but missing slip nut. Is there a special way to still use this pipe as is with a new plastic or metal trap?
you can use a rubber connector with two "O"ring which are usually attached to the rubber. so you take rubber connection and slip it on the P tighting it and then do the same with the other side should work cost about $ 2.50
Why the no load power factor is quite small in case of 3-phase induction motor?
Induction motors are designed for a certain power. If the power demand is lower than that, you still have to setup the magnetic fields as if you were going to supply that maximum power. As a result, the no-load power factor of an induction motor is quite small, i.e. poor.
Bathroom sink leak?
Take apart the drain and clean it up. Fit new seal, drain to bowl and new seal from slip tube to drain tube.
How is an alternating current produced?
EMF is induced in a coil when it is rotated in magnetic field. The magnetic field is obtained in the space between N Pole and S Pole of a magnet. coil is kept on shaft and it is rotated. To take out the current from the coil, two slip rings made of brass are kept on the shaft. The slip rings are insulated from each other and from the shaft. Carbon brushes are placed on the slip ring. EMF is available across these brushes. Load is connected across the brushes. This is called single phase type alternator or AC Generator. In practice three phase type alternator is used. In alternator, used in power stations, armature is kept stationary and field is rotated.
When induction motor is switched on the rotor frequency is?
The induction motor rotor has different frequency compared to it's stator. The rotor has slip ( s ) frequency. slip = ( Synchronous speed - rotor speed ) / Synchronous speed Synchronous speed = ( 120 * f ) / P where f = supply frequency to the stator. p = no of poles rotor speed is the actual speed the motor is running. Frequency in the rotor = slip * frequency in the stator At starting rotor speed is zero, so slip is one. Let us take the supply frequency is 50 Hz, then rotor frequency is also 50 Hz at starting. The motor attains speed and runs with its full speed at a point of time. Then let us take the slip is 0.04 then the rotor frequency will be 2 Hz.
Can you take a portable induction cooktop in your carry on luggage on an airplane?
induction cooker airplane
How can you remove a ring from a swollen finger?
Take soap and water. Rub the soap all over your hands and start to rinse. The ring will slip right off, even off a swollen finger. Or get a doctor to cut the ring and remove it.
How do stay with someone you love if they have cheated once?
with strength and never forgetting their actions cos if you do they will slip and its how many times you allow them to slip before you cant take no more. So basically all you'll be doing is waiting for them not to slip rather than waiting for them to slip
Induction in a sentence?
"the midwife gave me an appointment to have my labour Induced today
Where does the induction dinner take place?
it takes place in the night
How many hours does it take to get the red ring of death?
Four.. Atleast.
How many years did it take lebron to get a ring with the heat?
9 yrs
When was Take This Ring created?
Take This Ring was created in 2005-12.
Can someone prove that 2k2k plus 1-1 by induction?
To prove that 2k 2k plus 1-1 by induction is a step by step process. But the induction 2 is not equal to 2 to the power of 0 take away 1.
How many hours does it take for Neptune to turn on its ring?
it take s approximatley 16 hours and 6.7 minutes.
How many licks does it take to get to the center of a Tootsie Roll Pop if you have a tongue ring?
It takes 655321 licks with your stupid tongue ring. WOMAN
