answersLogoWhite

0

2. One to hold the light bulb and one to turn the ladder.

User Avatar

Wiki User

7y ago

What else can I help you with?

Related Questions

Did Justin Bieber scew caitlyn?

no no! No! NO! He didn't!


How do you change indicator lights on citroen xsara?

If you mean the rear ones you have to remove the rear light clusters,easily done by 2 clips inside the back of car[bit awkward to clip out but with a scew driver ok] Then just un clip the bulb holders and change the bulbs. Just push back into place.


What si emeritto in diamond?

scew u all


3 DNA Viral Diseases Prevented by vaccines?

scew off


How do you change a front park lamp bulb in a 99 Toyota Tacoma?

Lift up the hood and look at the corner wher the park assembly is, and do you see a little screw? Unscrew the screw and gently work back and forth and pull straight out. The park light assembly is held in place by one scew and the bottom of the assembly there is a plastic pin that's permenant that pops in and out from the frame assembly. Once you pop the light kit out, then you use your fingers to pinch the wiring connection tab and pull out the connection. Now atke a 1/4 turn on the bulb assembly and pull out. Change bulb and your done. Make sure when handling the bulb use a paper towel or rag because the oil on your hands will shorten the bulbs life. Keo


How do you replace tail lamp on 2003 Lexus LS 430?

Light bulb changed. I removed a Philips head screw under a plastic cover on the lower edge of the light housing. Slid the light assembly off the hook at the top and accessed the socket replaced the bulb. Slid the light assembly back on the hook, replaced the scew and snapped on the plastic cap covering the screw. Never did find two screws under the carpet in the trunk. Thanks, but we figured it out. I never found the Phillips screw. SOOO Open the Trunk at the back there are 2 little doors held closed with velcro. Open these doors. When you have figured out what is burned out, remember "Righty Tighty, Lefty Loosey". Rotate the socket mechanism left and gently pull the light and sockett out and remove the bulb. I suggest that if you have one out you should replace both right and left sides bulbs. Good Luck!


How do you remove the bolt on a model 18D springfield 12 gauge shotgun?

take out the scew on the bottom side of the barrel


Jeep Cherokee will not start without a scew driver jumping the ground wire to the starter?

Sounds like starter solenoid needs to be replaced


Is a shark's scales different from other fish?

yes, yes they are. Sharks are the baddest freaks in the ocean world, and they will eat u to SHREDS if u scew with them.


What happens if you eat a screw?

u die because the scew stabes u in ur thoght and blood starts poouring out and u bleed to death.


How do you put a Wii bat on the Wii remote?

First you have to have the bat,a wii remote, and the handle the bat hokes on to.Places the handle on the remote.Then simply scew on the bat.


How to install a mirror on a Chrysler?

installing a Chrysler mirrorFirst of all you would have to take of the door panel, there are about 6 0r 7 screws the first one is located behind the door handle and there is a cap in which you have to pop out with a scew driver and the other one is on the door handle ,down where you use your hand to close the door. Again you have to pop out the cap with a scew driver to get to the screw. then you will find about 4 scews around the speakers and take them out At the top of the door where the panel is there are about 3 10mm bolts