Want this question answered?
It's frustrating I know. It appears to be the "holy grail" of questions when it comes to Ruud Heat Pumps. Why? I have absolutely no good answer. On my Ruud Achiever Series Heat pump there is a test plug on Defrost Board. I found on post that said there should be two reset pins on that same board. But I can find none.
Sequencer stuck closed.
ruud furnace only blows cold air, no heat
I just had a 15 SEER Ruud Heat Pump installed. It says, 'Made in Mexico' on back of unit.
I'm afraid your question is not very clear. Your heat pump is basically an air conditioning unit with back up heat strips. If your thermostat is wired correctly and I'm certain it was from the factory, then the AC and heat strips will never come on at the same time. Is it not going into cooling mode? Ruud has wiring diagrams for most all their equipment on the internet. With a little research, you should be able to find yours. The Model # of your heat pump is the key to that.
Based on typical naming conventions - 42 - in the model number indicates 42,000 btuh nominal or 3.5 tons.
call a ruud or rheem dealer with the serial number on the unit tag.They should be able to answer this.
.belthermal.com/Portals/74941/docs/bhtr-inst-instr_.pdf
metal
No heat
No. Most model rockets do not reach very high into the atmosphere, and are thus not subject to severe re-entry drag and heat.
Any refrigeration supplier. You`ll need the compressor info, not the unit info. There is a tag with a Model#,Serial# and B/M# along with the electrical characteristics of the compressor. Get that info and go, that is all you need. The problem is you will need to have someone with the proper equipment and credentials recover the refrigerant charge as you can`t just blow it anymore, also you will need a person with the proper Federal credentials to buy new the gas as the supply house cannot sell it to you.