there is 3 bulbs
the fixture should either have side mounted screws or should twist off
Brake Light ColorMine are clear bulbs ["white"] light, but the bulbs are mounted in an assembly with a red lens.
Brake Light ColorMine are clear bulbs ["white"] light, but the bulbs are mounted in an assembly with a red lens.
Turn the wheels away from the side of the car that the light is on. Look on the front side of the wheel well for an access panel. A slot head screw driver can be used to remove the panel and access the light socket.
Check bulbs Check stop light switch Also make sure you have the right bulbs model 2057 bulbs.
Bulbs mis-installed, blown fuse, connector not plugged in, wrong bulbs, etc.Bulbs mis-installed, blown fuse, connector not plugged in, wrong bulbs, etc.
You will need a Torx T15 driver and however many 921 bulbs you have burned out. There are 3 bulbs in the center high-mount brake light assembly. Remove the 3 Torx screws right on the face of the plastic bar and the assembly, with the 3 bulbs mounted, comes down. The bulbs pull straight out of their sockets. Push the new bulbs into the blade sockets. Put the assembly back in place and replace the 3 screws.
Chrysler did not make a 300 in 1995. Turn signal bulbs are on each corner of the vehicle.
remove the 2 screws above headlights that you see when you lift the hood...then push whole assembly towards the center of the car to release clips. housing will come out then you can change bulb
I have successfully installed bulbs 3057, 3157 and 3457 in my Chrysler Town & Country mini-van, for the brake/stop lights.
1187 bulb
If the turn signal bulbs light up but they will not flash, the Flasher Relay is defective. You need to replace it. Purchase one so you will know what it looks like. It is located front seating area, center, under dash, mounted on center dash brace.