Two. New(right) Answer: The 4 cylinder motor in a 2001 eclipse is a 4g64 or 4g69 which are both SOHC motors which means there Single Over Head Cams. So the correct answer would be 1 not 2.
It should be next to one of the cams, is it a single cam or dual cam?
Two cams in a 1.8 ?
do you mean the cylinder head or the timing gears that mount on the cams .
2 cams per cylinder head ( so 4 in total for the DOHC engine )
when cylinder number one is at TDC, and the cams line up with there respective timing marks.Don't forget the crankshaft too.Only go clockwise.
2 ( 1 camshaft for each cylinder head )
The timing marks, on your Mitsubishi engine, can be found on the front main pulley. The timing marks will be on the outside edge of the pulley.
Fixed bits: cylinder head , cylinder barrel , crankcase. Moving bits: cams , valves , pistons , con rods , crankshaft.
The camshaft is a series of eccentric cams that are usually mounted on the cylinder head casting.The cams open and close the inlet and exhaust valve at precise times to enable fuel and gases to enter and leave the cylinders. Some engines have side valves and push rods where the camshaft is located below the cylinder block.
YES YES YES most saturns use either a 1.9 liter 4 cylinder inline SOHC engine 100 hp or 1.9 liter 4 cylinder inline DOHC engine 125 hp so as long as they are both single overhead cams or double overhead cams your fine
Cams Cams
Ford has a SPECIAL TOOL KIT with brackets that mount to the cylinder head. NO OTHER WAY