0
There are 3 coils on all 3100 gm
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change the distributor cap in a 1992 Cavalier Z24?
there ain't one eof those u have coil packs and no distributor
What order do the plug wires go on the coil pack of a 1989 Chevrolet Cavalier Z24 with a 2.8?
THE FIRING ORDER FOR A 2.8 V6 88 CAVALIER IS 1,2,3,4,5,6, THE COIL PACKS ARE 1-4 6-3 2-5
Is there some kind of chip that would cause my z24 to misfire I put new plugs and wires on.And I don't believe that I jummped timing.?
If its a third gen. z24 you should try to replace the coil pack housing on it. I had the same misfiring problem on my 97 z24. I replaced the plugs, plug boots, coil packs, camshaft position sensor, and crankshaft position sensor. After I replaced the coil pack housing, it stopped the misfire and made the engine run like it was supposed to.
How many spark plugs are in a 97 Chevy cavalier z24?
4...under the coil cover
Where on cap 87 d21 z24 truck motor does each coil wire go?
coil wireing order on 87 d21 z24 motor truck
Where is the starter on a 1989 cavalier Z24?
at the bottom of the block, under the coil pack
Will an engine from a 1987 Z24 Cavalier automatic work in a 1989 Z24 Cavalier V6 stick?
Yes. They are the same from 1987 until 1990
Do 18 inch rims fit a 1997 Chevy Cavalier Z24?
No...The stock coil-overs won't allow it.
What is the horse power of a 1990 cavalier Z24?
The stock horsepower is 140 for the 3.1L engine.
Can you change coils packs for a 89 cavalier z24?
Yes they are located front of block Remove air cleaner and fan and they become easy to reach
Where is ignition control module located on 1989 Chevy cavalier z24?
Behind the coil pack in the front lower center part of the engine.
How do you replace the coil pack modular on a 1990 Chevrolet Cavalier Z24?
well the 90 3.1 is the same as the 2.8 where the coil pack module is located underneath the front exhaust manifold to replace the module u have to take out all 3 coils leave the park plug wires connected and then disconnect the wires to the module and take out a couple of bolts and just replace it the way it was
