no the do not but some gaskets kits will come wit a egr gasket
The EGR valve and electrical transducer should be replaced at the same time as they are matched. Remove EGR transducer from the air inlet duct. Disconnect vacuum supply tube from EGR transducer solenoid. Remove air inlet duct. Remove EGR tube to EGR valve screws. Remove EGR valve mounting screws. Remove EGR valve and transducer. Clean gasket surfaces. Discard old gaskets. If necessary, clean EGR passages. Loosely install EGR valve with new gaskets and finer tighten EGR tube fasteners. Tighten tube fasteners to 95 in lb, tighten EGR valve mounting screws to 200 in lb. Install air inlet duct. Connect vacuum supply tube to solenoid. Attach electrical connector to solenoid. Install EGR transducer onto air inlet duct.
The Zafira 1.8 automatic does not have an EGR Valve. These vehicles had a Z18XE engine, and were not equipped with the EGR Valve as there was no need for one.
It is possible that a part of the EGR valve has fallen out. This will cause a very loud exhaust noise.
The 2002 4.3L has an EGR valve, at least mine does.
# The EGR valve is bolted to the rear cylinder head,at the transaxle end # Remove the air intake duct from the throttle body and air filter housing # Detach the vacuum line from the EGR valve.Disconnect the EGR pipe nut # Remove the EGR valve mounting fasteners # Remove the EGR valve and gasket from the manifold.Discard the gasket
Never heard of an EGR pump and need to know what year, make, model, engine and what valve you are looking for.
The EGR valve is located at the front of the h22a4 engine. The EGR valve is right beside of the front of the EGR valve.
Yes, clean the cabor buildup from the EGR valve and that pipe.
You mean the egr valve? Rios have precise timing with lower compression no need for an egr vale.
The vehicle manufacturer will quote a torque figure for the EGR valve but in practice most mechanics no not torque them.
You need to CHECK the EGR Valve.