5 per wheel, 20 total.
A 2007 Jeep Grand Cherokee has twenty lug nuts.
5 lug nuts per wheel
The 2005 Jeep Grand Cherokee emergency brake cable has adjustment nuts on each end of the cable. Turn the adjustment nut to lengthen or shorten the cable.
No, you remove the 4 nuts on the outside, and pull the axle shaft out with a slide hammer.
undo the bolts/nuts that hold it on .... take the fan off .... replace the fan and put the bolts/nuts back in and tighten them up ... bingo .... fan changed
Disconnect your battery, then remove the two nuts from the starter wire harness. Pull the wire and cable of the studs. Remove starter bolts and slide starter out of bellhosing.
Disconnect your battery, then remove the two nuts from the starter wire harness. Pull the wire and cable of the studs. Remove starter bolts and slide starter out of bellhosing.
First jack up the front wheels off the ground and check all suspension parts for play.
To remove the sway link kit on a 1998 Jeep Grand Cherokee, start by safely lifting the vehicle and supporting it with jack stands. Use a wrench to remove the nuts securing the sway bar links to the sway bar and the lower control arms. If the bolt spins while you try to remove the nut, you may need to hold it with a second wrench or use penetrating oil to loosen any rust. Once the nuts are removed, pull the sway links out from their mounts.
Jack it up. Put jack stands or blocks under it to support it safely. Pry off the hub caps (if it has any). Take off the lug nuts (someone may have to hold the brakes on for this part). PRESTO CHANGO the wheels are off your Jeep.
Drain the water coolant from the engine. Remove the water hoses. Remove the front engine cover. Remove the retaining nuts from the water pump. Reverse the process to install the new water pump.
I have a 94 and the plug is on the engine side lower left if you are standing in front of the vehicle. It will be much easier if you remove the fan shroud and core support. Between the two there is a total of 8 10mm bolts/nuts to remove.