Cars & Vehicles
Dodge Intrepid

How many motor mounts in a 1997 Dodge Intrepid?

001

Top Answer
User Avatar
Wiki User
Answered
2017-03-31 09:23:59
2017-03-31 09:23:59

A 1997 Dodge Intrepid has two engine mounts and one transmission mount.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Two on the engine, one on the trans.Two on the engine, one on the trans.

No. The 1997 computer system is completely different than the 1999 system.

The 1997 Ford Taurus has for motor mounts and to transmission mounts. Worn motor mounts and transmission mounts will allow the engine and transmission to have movement.

1996-1997 Dodge Intrepid, Chrysler Concorde, Chrysler LHS, Eagle Vision.

The 1997 Buick is equipped with four motor mounts. There will be to motor mounts on the rear of the engine and two motor mount on the front of the engine.

No, a 1997 Dodge does not have a cabin filter.

where is torque conversion sensor on my 1997 didge intrepid?

Check the phone book under Auto Parts and Supplies -- Used

Where is fuel presure regualtor located on 1997 dodge intrepid 3.5 engine ?

Dodge doesn't use inertia switches.

yup i have a set off a 2000 on my 97 they fit perfect

I used the remote to lock/unlock the doors and it reset the anti-theft on a 1997 Dodge Intrepid.

At minimum, removing the engine mounts is required to access the freeze plugs.

The curb weight of the Dodge Intrepid in 3,318 pounds of 1,505 kilograms. It was produced for model years 1993 until 1997.

If you have a 3.5 liter motor, take it to an independent shop, I would not recommend it for d-i-y ers.

Bad fan motor - check to see if you are getting power to the 2nd

Dodge doesn't use reset switches.

The 1997 Cavalier has two motor mounts, as well as a transmission mount. If the mounts are broken the motor can move around and cause damage to components under the hood.

The plug gap for the 97 intrepid 3.5 is .035.

Carefully place a jack with a block of wood under the motor, loosen mounts from motor, jack motor up just enough to remove old mounts, replace mounts, lower motor onto new mounts, tighten motor to mounts. Make sure there aren't any hoses, wires, lines, etc. that may tear while lifting the motor.

You have to unbolt the wipers off the car then take off the cowl panel by either bolts or clips then the motor should be exposed then simply unbolt it.

You should check your motor mounts

If same size engine, yes.If same size engine, yes.

Any Pioneer or Sony decks will fit very well in any Dodge Intrepid, and will look good, too.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.