answersLogoWhite

0


Best Answer

Start with 1and1/2 turns out on both high and low

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How many turns out on the high low fuel mix to get a 2.0 chain saw to start?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Turns over will not start any ideas on a 1998 Chevy blazer?

When was the fuel pump last replaced, to save time, money, aggravation, check or have fuel pressure checked. These blazers need a high fuel pressure I believe at least 59psi. You must have entire fuel pump assembly replaced on these Blazers, can get one at auto zone for around $200.00


How does a high pressure fuel pump work?

It is a gear or chain driven compressor, piston or rotor(like new oil pumps). It is feed fuel by a normal fuel pump at around 43psi and compresses it up to 25,000psi.


Will a knock sensor start working correctly if you start using a high octane fuel?

Perhaps--unless the sensor itself is bad.


Where to get Carb settings for 1980 Suzuki gs 550 e?

start with 2 1/2 turns out on high speed needle start with 1 1/2 on your low speed needle. adjust high as needed


Ford F150 won't start not getting fuel to fuel rale changed fuel filter and checked high pressure fuel pump not even getting fuel to there?

check the fuel pump driver moduel located behind the spare tire


Will a car start if it needs a fuel filter?

It depends on how blocked the filter is. It could be blocked enough that it won't let the vehicle run at high speed, but still allows enough fuel through to start the engine.


Signs of a bad fuel pressure regulater?

Fuel in oil, engine running rich( black smoke out of exhaust) Fuel pressure to high, Spark plugs black in color. Hard to start.


What is the cold start pipe on the 1987 pontiac fiero gt fuel rail?

There is a high pressure fuel line under the throttle body that carries fuel to the cold start injector. There is a black pipe that feeds idle air to the same spot to insure the cold start injector gets a good mixture.


Why rail pressure goes high when engine is on?

Engines need higher fuel pressure to start than they do to run.


How do you remove the governor on a 2000 Chevy Malibu?

no governor!! the ecm turns power off to the fuel pump at high speed, should happen around 104 mph


Your 1993 s10 blazer wont start you were driving one day and it just died like it was out of gas you can still hear the fuel pump come on and you already changed the fuel filter but still wont start a?

check fuel pressure i think it should be 54-60psi if not high enouth its fuel pump


Where are wolverines in the food chain?

Pretty high on the food chain