0
What else can I help you with?
What is the bulb type on a 2001 lanos?
The 2001 Daewoo Lanos uses H4 halogen bulbs for its headlights.
What size is the wheel on a Daewoo lanos?
I think that depend on the engine type and/or the country whwre is has been bought. I am looking for the same info for my Lanos, to be more precise, the tyre width.
What grade engine oil for Daewoo lanos?
The recommended engine oil for a Daewoo Lanos is typically 10W-30 or 10W-40, depending on the climate and operating conditions. It's essential to refer to the owner's manual for specific recommendations based on your model year and engine type. Using the correct viscosity helps ensure optimal engine performance and longevity.
What is the right type of transmission fluid for the 2001 Daewoo Lanos 1.6?
2002 1.6 DOHC manual states SAE 80W for manual transmission & Dextron III for Automatic transmission.
What type of coolant is used in a 98 1.5 Daewoo Lanos?
The 1998 Daewoo Lanos typically uses a mixture of ethylene glycol-based coolant and water, often referred to as antifreeze. It's recommended to use a 50/50 mix of coolant and distilled water for optimal performance. Always check the owner's manual for specific recommendations and ensure the coolant meets the required specifications for your vehicle.
What is the fuel pump pressure in a Daewoo Lanos 2000?
The fuel pump pressure for a 2000 Daewoo Lanos typically ranges between 35 to 43 psi (pounds per square inch). It's important to refer to the vehicle's service manual for specific specifications, as variations can occur based on the engine type and model. Proper fuel pressure is crucial for optimal engine performance and fuel efficiency.
Where do you put power steering in a Daewoo lanos?
In a Daewoo Lanos, power steering fluid is typically added to the power steering reservoir, which is usually located near the engine, towards the front of the vehicle. The reservoir is often labeled and has a cap that can be unscrewed. Make sure to use the correct type of power steering fluid as specified in the owner's manual. Always check the fluid level and top it off if necessary, ensuring not to overfill.
How do you remove air con compressor in Daewoo Nubira?
Needs to be done by person certified to handle refridgerant properly evacuate system replace compressor vaccuum system and leak check properly add correct type and amound of compressor oil properly add refridgerant
How do you check the transmission fluid in a 2001 Daewoo Lanos?
To check the transmission fluid in a 2001 Daewoo Lanos, first ensure the vehicle is on level ground and the engine is running at normal operating temperature. Locate the transmission dipstick, which is usually found near the back of the engine compartment. Pull out the dipstick, wipe it clean, reinsert it, and then remove it again to check the fluid level against the marks on the dipstick. If the fluid is low, add the appropriate type of transmission fluid as needed.
What are the head torque settings for a Daewoo Lanos sx?
The head torque settings for a Daewoo Lanos SX typically require a sequence of tightening to ensure even pressure on the cylinder head. Generally, the initial torque should be set to about 30 Nm (22 lb-ft), followed by a second stage of 60 Nm (44 lb-ft), and then an additional turn of 90 degrees. Always refer to the specific service manual for the vehicle, as torque specifications can vary based on engine type and model year.
What are the alternate spark plug wires for a Daewoo Lanos 2000?
For a 2000 Daewoo Lanos, alternative spark plug wire options include aftermarket brands like ACDelco, Bosch, and NGK. It's important to ensure that the wires match the specifications for the vehicle’s engine type, typically a 1.6L inline-4. Always check compatibility with your model year and engine configuration before purchasing. Additionally, consulting with a local auto parts store or mechanic can provide further guidance on suitable options.
How do you change the oil on a 2000 Daewoo Lanos?
To change the oil on a 2000 Daewoo Lanos, first, ensure the engine is cool and secure the vehicle on a level surface. Remove the oil drain plug located under the engine and allow the old oil to fully drain into a pan. Replace the drain plug, then remove the old oil filter using an oil filter wrench and install a new filter. Finally, refill the engine with the appropriate type and amount of new oil through the oil filler cap.
