27.5 degrees
A butt weld is a weld made between two straight cut profiles , a socket , or plug weld is made between a surface and a hole.
tell me full penetration joint process
I think you mean root pass. An example would be when butt welding two pieces of plate together (end to end). You would grind a bevel (angle) along the edge of each plate so when you put them end to end there is a small gap between them except at one small point at the bottom. This gap will be filled with molten weld metal to fuse the two plates. Typically, this gap cannot be filled up by one pass with the weld electrode. The welder will go back and forth along the plate eventually filling the entire gap. The "root pass" is simply the first pass the welder makes.
A butt weld is where the diameter of the pipes welded together are the same, a socket weld is where a larger diameter pipe is fitted into a smaller one. In making a butt weld, the pipes (or pipe and fitting) usually have an angle machined or ground into the outside corner, so when they are placed together face-face, there is a circumferential V shaped gap serving as the weld prep. In a socket weld, the pipe is inserted into the socket, backed off slightly to make a gap between the end of the pipe and the bottom of the socket, and the weld is made around the outside diameter of the socket to the outside diameter of the pipe. The gap at the bottom of the pipe prevents thermal expansion from stressing the joint during or after welding.
it came from your butt THAT was rude.
37&1half
You always weld the side with the preperation first, then if you get incomplete penetration you can grind the back out
Back shots can make your butt look big. You can try taking shots in more of an angle to make your butt not look as big.
shut up you butt head
This process, called the butt-weld process is the basis for our current pipe-making procedures. In his method, thin sheets of iron were heated and drawn through a cone-shaped opening. As the metal went through the opening, its edges curled up and created a pipe shape. The two ends were welded together to finish the pipe. The first manufacturing plant to use this process in the United States was opened in 1832 in Philadelphia. So the method is the two sides are welded as they butt together without overlapping. The same method is used to weld two pipes together as they are butted together and welded around the seams.
He/she thinks your looking at there butt. Chest or between there legs for female or butt or between legs for male
There are various ways to classify chisels: Type of duty: Framing or mortise, Paring, Firmer. Length of blade: Butt, Pocket, Mill. Abnormal width of blade: Slick. Edges of blade: Plain, Bevel. Method of attaching the handle: Tang, Socket. Shape of the blade: Flat, Round (gouge), L (corner). So a bevel edge chisel has bevel edges and the term firmer applies to a medium duty tool, a more substantial tool than the paring chisel for general work such as paring or light mortising. There are descriptions of the various types of chisel along with drawings at `Sharp Edge Cutting Tools - Chisels' - http://www.inquirewithin.biz/Vol1/Tools/cutting_tools/chisels.htm.
It is between the two muscles called the gluteus maximus. These form the "butt cheeks".
eubacteria likes it in the butt. i said what what in the butt.
a butt
No
its butt