none it is a pully not a push lol
6-8 on stock 3.8 pulley. max is about 15-17.
boost
push-up Bras give a little boost on your boobs and makes them LOOK bigger!
There should be an extra pully. This pully appears to not go to anything, however it's job is go keep the belt tight. I don't recall the wrench size, I think it's 16mm. Put the wrench on the pully's center nut and push or pull towards the center, this should move the pully enough to get the belt off.
it is usually running about 8 or 9 pounds stock but if you get a boost control the most you can push is 15 pounds
depends on how much pound of boost ur pushing, u cant really say how much hp can u get without having a dyno tune to see how much ur car can push
any internal combustion engine can use a turbo or SC, the question is how much $$ and how long will motor last with the added stress. Which will be determined also by how much boost you choose to push.
A stock eagle talon tsi's 4g63t motor produces... 5 Speed 210 HP at the Crank Automatic 205 HP at the Crank Now for turning up the boost level its very easy. All is required is to buy a boost guage... and boost controller. Once you have that its a simple turn of a knob. 90-94 Talons come with 14b Turbos. Can easily and efficiently push out 200-320 HP with the right tuning and piping.
Under hood pasanger side losen three bolts in motor mount about 3/4 in,may pry down with flat screwdriver. This will drop motor. Remove belt and pump bolts and pully bolts push pully back. Now pully will fall in hand. P s drain fluid first.
Find the idler pully of the serpentine belt system. It is usually the one that appears to not "drive" any system and is normally located towards the top of the other pullys. On the idler pully assembly, you will find a bolt (not the bolt in center of pully or the one at the pivot point of assembly). Using the correct sized socket and a large ratchet (or wrench) as a lever, pull or push the idler pully assembly, which is spring tensioned, until the pully moves in far enough to get new belt on. Slowly release tension until belt is tight against the idler pully under the assembly's spring tension. Be sure belt is properly seated on all pullys without any twists.
Yes, doing push-ups in the morning can help wake you up by increasing blood flow and activating your muscles, leading to a boost in energy and alertness.
Go to your local auto parts store, and get a power stearing pully installer/remover. Sounds to me like you are just trying to use a bolt. That would work you need to get a longer bolt with a nut and large strong washer. place the nut on the bolt, thread it to the top,put on the washer, place the pully where it goes screw the bolt in til it bottoms out DONT FORCE, now tighten the nut down on the washer and pully you should be able to push the pully all the way on now.