Want this question answered?
Your question is unclear. But, if you are asking what the relationship between voltage and the distance between conductors is, then the higher the voltage, the greater the distance must be.
It is the shortest distance between the conductors measured along with the surface of insulators.
Bundled conductors are used to reduce the effect of corona. As in place of a single conductor. two conductors are used in parallel the voltage gradient build up is less and thus the ionisation of the surrounding air is decreased. Therefore the effect of corona is reduced.
Power lines and electronic equipment: 150m
33 kV line, it should be 3.7 mtrs
The minimum electrical clearance is the minimum distance between electrical conductors with different potentials (voltage). This generaly determined by the maximum possible voltage differenge between the conductors. Dimensions larger then the minimum electrical clearance are OK, however smaller dimensions start to risk arc-over between your conductors.
It varies, according to their height, and the landscape (i.e. the levels of the ground) between towers, as well as upon any restrictions on where towers may be built. The determining factor is to ensure that the ground clearance of the conductors remain above their regulation clearance.
Overhead lines have 'sag' (not 'slack') because the conductors need to be able to expand and contract as the temperature changes. If sag isn't built into the design of the line then, when the conductors contract, they will put undue lateral strain on the supporting poles or towers. It is important that, with maximum sag, the minimum clearance distance between the line conductors and the ground below is always maintained. This safety clearance increases, of course, with line voltage. Allowing for the necessary sag part of the design-process for any overhead line, and achieving it becomes the responsibility of the linesmen when the line is eventually constructed.
600mm is the distance between two conductors in 11kv line
Ground clearance in a substation is the distance between wires and the ground or other objects such as buildings. Sectional clearance is the distance between the wires themselves in a substation.
Your question is unclear. But, if you are asking what the relationship between voltage and the distance between conductors is, then the higher the voltage, the greater the distance must be.
Bearing clearance is the distance between the crankshaft journal and the bearing surface. It is usually referred to as oil clearance, as that's what is occupying the space.
It is the shortest distance between the conductors measured along with the surface of insulators.
50 feet
Bundled conductors are used to reduce the effect of corona. As in place of a single conductor. two conductors are used in parallel the voltage gradient build up is less and thus the ionisation of the surrounding air is decreased. Therefore the effect of corona is reduced.
far if your seen as suspisious they will search you or just warn you too keep distance
100 yd